665009
116
Zoom out
Zoom in
Previous page
1/124
Next page
107107
12
CONNECTIONS AND MAINTENANCE
Microphone installation
The supplied or optional HM-205* and the optional HM-195
should be connected to the transceiver using the connection
cable that comes with the transceiver or the microphone.
The cable is used to operate from a longer distance. The
cable connector can also be installed as a built-in plug on a
cabinet or wall.
*Not supplied with some transceiver versions.
To operate from even longer distances, the optional 6 meter
long OPC-999 or OPC-1541 extension cable can be used be-
tween the transceiver and the OPC-1000 or OPC-1540. Up to
two OPC-999 or OPC-1541 can be added.
• OPC-999: For the HM-205
• OPC-1541: For the HM-195
D Installation
q Insert the connection cable connector into the microphone
connector or the command microphone jack, and tighten
the nut.
w To use the cable connector as a wall socket, install it as
described below.
e Using the mounting base as a template, carefully mark the
holes where the cable and three screws will be fastened.
r Drill holes at these marks.
t Install the mounting base using the supplied screws, as
shown below.
• HM-205
• HM-195
Gasket
Cap
Mounting base
Nut
Screw holes
(approximately 2 (d) mm; 0.1 inches)
Gasket
Cap
Mounting base Nut
Screw holes
(approximately 2 (d) mm;
0.1 inches)
116


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-M506 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-M506 in the language / languages: English as an attachment in your email.

The manual is 5,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info