670364
26
Zoom out
Zoom in
Previous page
1/48
Next page
22
4
BIIS OPERATION
DD
Direct code entry
q While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
Code digit for editing blinks.
w Push [P3] (TX Code Enter) to select the desired digit to be
edited.
Digit for editing differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down] or 10-key-
pad*.
*IC-F70DT/T or IC-F80DT/T only
r Push [P3] (TX Code Enter) to set the digit, then the digit
to the right will blink automatically.
When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
WAIT is displayed during each call. However, an
error beep sounds and
FAILEDis displayed when no
answer back is received after the calls.
u Push [PTT] to transmit; release to receive.
i Push [P4] (Moni(Audi)) to send the Clear down signal.
For your information
When the UpDate setting for the call code is enabled, the
set code is overwritten into the call code memory.
X
IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 22 (1,1)
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-F80T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-F80T in the language / languages: English as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info