12528
32
Zoom out
Zoom in
Previous page
1/36
Next page
29
5 CONNECTION AND INSTALLATION
New2001
DD
UT-109/UT-110/UT-117S installation
Install the optional unit as below.
qTurn power off, then disconnect the DC power cable.
wUnscrew the 4 screws, then remove the bottom cover.
eCut the print patterns on the PCB at the transmit mic cir-
cuit (MIC) and receive AF circuit (AFO) as shown in the di-
agram below.
rInstall the unit as described in page 28.
tAttach the bottom cover and screws to their original posi-
tion, then connect the DC power cable.
NOTE: Be sure to re-solder above print
patterns, when you remove the scrambler
unit. Otherwise no TX modulation or AF
output is available.
DD
OPC-617/822 installation
Either the optional OPC-617
ACC CABLE
or OPC-822
INTER
-
FACE CABLE
can be installed.
Install the OPC-617 or OPC-822 as shown bellow.
OPC-617
OPC-822
A
B
IC-F521 Series_BIIS-2.qxd 05.10.26 11:30 AM Page 29 (1,1)
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-F521 F621 EX(BIIS) at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-F521 F621 EX(BIIS) in the language / languages: English as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info