14
4
MEMORY OPERATION
■ Memory names
ï Programming memory names
The memory channel can display a 6-character names in-
stead of the programmed frequency.
q Rotate [DIAL] to select the desired frequency in the fre-
quency mode.
w Push
,
then push [MR•
MW] to program the contents
into the selected memory channel.
e Rotate [DIAL] to select the desired memory channel to be
programmed.
• Push [0•BANK
] to select the BANK number if desired. Push
[CLR•
DEL] to exit the BANK selection mode.
r Push [MR•MW] to enter the memory name programming
mode.
•“-- -- -- -- -- -- ” appears on the display.
t Push the appropriate digit key several times to select the
desired character as listed at right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y Push [ENT•WX] to program the name.
• Flashing the memory name stops.
• When no name is programmed, the display shows the operating
frequency.
• To clear the programmed memory names, push [CLR•DEL] be-
fore pushing [ENT•WX].
■
Clearing the memory contents
Unwanted memory channels can be cleared. Programming
over a memory channel also clears the previously pro-
grammed contents. Memory channel 1 cannot be cleared.
q Select the memory channel to be cleared.
w Push
,
then push and hold [CLR•
DEL] for 1 sec.
•“-- -- -- -- -- --” appears momentarily, then the next selec-
table channel appears.
Key Character Key Character Key Character
1 1, Q, Z 2 2, A, B, C 3 3, D, E, F
4 4, G, H, I 5 5, J, K, L 6 6, M, N, O
7 7, P, R, S 8 8, T, U, V 9 9, W, X, Y
ENT Program 0 0, space, -
4
