670164
102
Zoom out
Zoom in
Previous page
1/104
Next page
18
97
BAND VOLTAGE MODIFICATION
Band voltage modification
If you want to connect an external unit which can be
controlled by the band voltage from [ACC] connector,
the modification is necessary as at right.
The band voltage appears from pin 5 of [ACC] con-
nector after modification (q) is completed, or the
regulated 8 V appears from pin 1 of [ACC] connector
after modification (w) is completed.
Performing this modification is the customer’s re-
sponsibility. Icom does not guarantee this modifica-
tion’s result.
CAUTION: Disconnect the DC power cable from
the transceiver before any work on the transceiver.
Bridge these
solder pads
IC-7200’s bottom view with
bottom cover is opened.
RF unit
Front panel
q BAND
w 8 V
• Band voltage generator circuit
The below circuit is just for reference.
1.9 MHz
Rotary
switch
Diode
VR 4.7 kø
4.7 kø
4.7 kø
100 µH
100 µH
4700 pF
4700 pF
4700 pF
BAND
8 V
8 V
External
power souce
ACC socket of
an optional unit
GND
10 kø
10 kø
22 kø
VR
Open
VR
VR
OR
3.5 MHz
7 MHz
10 MHz
14 MHz
18/21 MHz
24/28 MHz
1
2
3
4
7
6
5
The following band voltage table is for reference only.
Please adjust and confirm against the actual operat-
ing condition.
BAND VOLTAGE
1.9
MHz Non-adjustment
3.5
MHz 6.1 V
7
MHz 5.1 V
10
MHz Non-adjustment
14
MHz 4.1 V
18/21
MHz 3.1 V
24/28
MHz 2.1 V
102


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-7200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-7200 in the language / languages: English as an attachment in your email.

The manual is 10,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info