12296
54
Zoom out
Zoom in
Previous page
1/88
Next page
DTMF MEMORY ENCODER
11
49
Programming a DTMF code
DTMF codes are used for autopatching, accessing repeaters,
controlling other equipment, etc. The transceiver has 8 DTMF
memory channels (d1 d8) for storage of often-used DTMF
codes of up to 16 digits.
NOTE: DTMF memory channels are commonly used for
both bands. Therefore, programming each band is not
necessary.
Push [DTMF] once and d appears in place of the main
bands 100 MHz digit as shown below.
Push [(VOL)SET] to enter the programming condition.
Rotate the main bands tuning dial to select the desired
channel.
Push [SET] or [MONI] to select the cursor.
Rotate the main bands dial to select a digit.
•“E stands for M and F stands for #.
Repeat steps and until the last digit is entered.
The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
Select “–” to clear the remaining digits when programming over a
previously used memory channel.
Push the main bands tuning dial to exit the programming
condition.
Clearing the DTMF memory
contents
Push [DTMF] to turn the DTMF memory encoder ON.
Push [SET] to enter the programming condition.
Rotate the main bands tuning dial to select the desired
channel.
Push [SET L] (for VHF display) or [MONI] (for UHF display)
to activate the 1st digit.
Rotate the main bands tuning dial to select “–” and clear
the memory channel contents.
Push the main bands tuning dial to exit the programming
condition.
d appears in place of
the 100 MHz digit.
IC-2710H.qxd 02.2.8 16:55 Page 49 (1,1)
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-2710H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-2710H in the language / languages: English as an attachment in your email.

The manual is 1,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info