12296
16
Zoom out
Zoom in
Previous page
1/88
Next page
2
INSTALLATION
11
Microphone connection
The microphone connector is located behind the front panel.
Connect the supplied microphone as follows:
Push the release button, then detach the remote controller
as shown below.
Connect the supplied microphone to the microphone con-
nector.
Reattach the remote controller to the main body.
To remove the microphone, push the release button as
above.
Separate installation
Using an optional OPC-600/601
SEPARATION CABLE
, the front
panel can be separated from the main body, doubling as a re-
mote controller.
Detach the front panel as shown at left.
Connect a separation cable to the front panel and to the
main body using the supplied screws as illustrated below.
mic release
Push
Release
button
OPC-600 or OPC-601
Rear of front panel Main body
8 V OUT
Freq. up/down
8 V control IN
PTT
Mic AF ()
Mic AF (+)
Ground
Data IN
Microphone pin assignments
IC-2710H.qxd 02.2.8 16:55 Page 11 (1,1)
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-2710H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-2710H in the language / languages: English as an attachment in your email.

The manual is 1,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info