12250

Icom IC-2200H Manual

102
Zoom out
Zoom in
Previous page
1/108
Next page
89
MAINTENANCE
15
PROBLEM POSSIBLE CAUSE SOLUTION REF.
■ Troubleshooting
If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
No power comes on.
No sound comes from the
speaker.
Sensitivity is low and only
strong signals are audible.
No contact possible with
another station.
Repeater cannot be ac-
cessed.
Frequency cannot be set.
Frequency cannot be set
via the microphone.
• Power connector has a poor contact.
• Polarity of the power connection is reversed.
• Blown fuse.
•Volume is too low.
• The audio mute function is activated.
• Squelch is set too tight.
•Aselective call or squelch function is activated
such as pocket beep or tone squelch.
• Antenna feedline or the antenna connector solder
has a poor contact or is short circuited.
• Squelch attenuator function is activated.
• The other station is using tone squelch.
• The transceiver is set to duplex.
•Wrong offset frequency is programmed.
•Wrong subaudible tone frequency is programmed.
• The frequency lock function is activated.
• Priority watch is paused on the watching frequency.
• The frequency lock function is activated.
• The microphone keypad lock function is activated.
• Priority watch is paused on the watching fre-
quency.
• Check the connector pins.
• Re-connect the power cable observing the proper
polarity. Replace the fuse if damaged.
• Check the cause, then replace the fuse.
• Rotate [VOL] clockwise.
• Push any switch or key to deactivate it.
• Set the squelch level to the threshold.
•Turn the appropriate function OFF.
• Check, and if necessary, replace the feedline or sol-
der the antenna connector again.
• Set [SQL] between 10–12 o’clock position.
•Turn the tone squelch function ON.
• Set to simplex.
•Correct the offset frequency.
• Correct the subaudible tone frequency.
•Turn the function OFF.
• Push [M/CALL ] to cancel the watch.
• Push [SET ] for 1 sec. to deactivate the fre-
quency lock function.
• Push [FUNC] then [#(16KEY-L)] to deactivate the
microphone keypad lock function.
• Push [M/CALL ] to cancel the watch.
PRIO
LOCK
PRIO
—
pgs. II,
90
p. 90
p. 13
p. 14
p. 13
pgs.
48,
49, 50
p. III
p. 14
p. 50
p. 17
p. 21
p. 19
p. 12
p. 44
p. 12
p. 12
p. 44
… 102 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-2200H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-2200H in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info