12206
5
Zoom out
Zoom in
Previous page
1/8
Next page
4 RX Speaker function
q Push [HAIL•RX ] for 1 sec. to
enter the RX Speaker mode.
•“ ” indicator appears.
The audio output level for the RX
speaker can be adjusted when
entering this mode. Rotate [SE-
LECTOR] then push [ENT].
Or while pushing [HAIL•RX ], rotate [SELECTOR] before
tuning this function OFF (within 1 sec.).
w To cancel the RX Speaker mode, repeat step q.
•“ ” indicator disappears.
BUSYBUSY-25W25W------INTINT---CALL---CALL
LOCALOCARXRX
--
UPUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
RXRX-
15154"34.206N4"34.206N
123"23.236W123"23.236W
-<ENT<ENT˘OK>OK>---- CALLINGCALLING
[CH[CH-]
5 Hailer function
q Push [HAIL•RX ] to enter the
hailer mode.
w Push and hold [PTT] and speak
at a normal voice level.
•“
TTAALLKK
” appears.
•“
WWAAIITT
” appears while the trans-
ceiver side is in use.
•To adjust the hailer level, rotate [SELECTOR].
e After speaking, release [PTT].
r To cancel the hailer mode, repeat step q.
Pushing [16•C] also cancels the hailer function.
While in the hailer mode, the transceiver functions (transmit
and receive) are interrupted. If the transceiver is in transmit
condition, the hailer function is not available.
BUSY-25W---INT---CALLBUSY-25W---INT---CALL
LOCAL--DUPLOCAL--DUP
SCRAM--TAGSCRAM--TAG
NORMAL-SCANNORMAL-SCAN
HAILERHAILER
LISTENLISTEN
1515.236W.236W
_______al--1:10--CALLINGl--1:10--CALLING
8 Automatic foghorn
The automatic foghorn function sounds a horn repeatedly until
the function is turned OFF. Four patterns are available for vary-
ing conditions.
The foghorn outputs from the hailer speaker. To use this func-
tion, the hailer speaker must be connected to the transceiver.
See the transceiver’s instruction manual for connection details.
The audio frequency of the foghorn is selectable in Set
mode.
q While pushing and holding
[H/L], push [HAIL•RX ] to
enter auto foghorn mode.
w Rotate [SELECTOR] to select
the desired foghorn pattern,
push [ENT].
•‘
UUNNDDEERRWWAAYY
,’ ‘
SSTTOOPP
,’ ‘
SSAAIILL
,’
TTOOWW
are available.
Even if [ENT] hasn’t been
pushed, the display automati-
cally changes to the next step
after 5 sec. of inactivity.
e Rotate [SELECTOR] to adjust
the foghorn level, push [ENT].
The foghorn level is adjustable in
30 steps.
Even if [ENT] hasn’t been
pushed, the display automati-
cally changes to the next step
after 5 sec. of inactivity.
[VOL][VOL]
BUSY-BUSY-25W25W------INTINT---CALL---CALL
LOCARXLOCARX
----
UPUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
FOGHORNFOGHORN
15154"34.206N4"34.206N
123"23.236W123"23.236W
-<ENT<ENT˘OK>OK>---- CALLINGCALLING
BUSY-BUSY-25W25W------INTINT---CALL---CALL
LOCARXLOCARX
----
UPUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
FOGFOG
15154"34.206N4"34.206N
123"23.236W123"23.236W
-UNDERWAYUNDERWAY---- CALLINGCALLING
[VOL][VOL]
The selected foghorn
pattern is displayed.
[VOL][VOL]
BUSY-BUSY-25W25W------INTINT---CALL---CALL
LOCALOCARXRX
--
UPUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
˘UNDERWAYUNDERWAY
-STOPSTOP4"34.206N4"34.206N
123"23.236W123"23.236W
-<ENT<ENT˘OK>OK>---- CALLINGCALLING
7 Intercom operation
q Push [IC] to activate the Inter-
com function.
w Push and hold [PTT] to talk.
•“
IINNTTEERRCCOOMM TTAALLKK
” appears.
e Release [PTT] to listen.
•“
IINNTTEERRCCOOMM LLIISSTTEENN
” ap-
pears when the transceiver is in
talking mode.
•To adjust the audio outoput level,
push [VOL/SQL] then rotate
[SELECTOR
VOL
].
r Push [IC] to cancel the Intercom
function.
Pushing [16•C] also cancels the
Intercom function.
For your reference:
In case the Intercom mode is selected with the transceiver while
the microphone power is OFF, the microphone power is auto-
matically turned ON and the Intercom mode is selected.
DD
Intercom beep function
Push and hold [IC] for more than 1 sec.
Emits the Intercom beep while holding.
BUSY-BUSY-25W---INT-25W---INT---CALL--CALL
LOCAL--DUPLOCAL--DUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
INTERCOMINTERCOM
TALKTALK
123"23.236W123"23.236W
--UTC-10:10--UTC-10:10COMMERCIALCOMMERCIAL
BUSY-BUSY-25W---INT-25W---INT---CALL--CALL
LOCAL--DUPLOCAL--DUP
SCRAMSCRAM----TAGTAG
NORMAL-SCANNORMAL-SCAN
INTERCOMINTERCOM
LISTENLISTEN
123"23.236W123"23.236W
--UTC-10:10--UTC-10:10COMMERCIALCOMMERCIAL
5
3 Display backlight
The function display and keys can be backlit for better visibility
under low light conditions. The backlighting condition can also
be adjusted independently from the transceiver.
While pushing [H/L], rotate [SE-
LECTOR] to adjust the backlight
level.
•“
BBAACCKKLLIIGGHHTT
” with the back-
light level appears.
The backlight is adjustable in 7
levels and OFF.
BUSY-25W25W------INTINT---CALL---CALL
LOCAL--DUPLOCAL--DUP
SCRAMSCRAM--TAG--TAG
NORMAL-SCANNORMAL-SCAN
BACKLIGHTBACKLIGHT
-7
-<ENT<ENT˘OK> COMMERCIALOK> COMMERCIAL
Appears
AquaQuake helps drain water away from the speaker housing
(water that might otherwise mufe the sound coming from the
speaker). The HM-162E emits a vibrating noise when this func-
tion is being used. This function is availabe depending on the
connected transceiver.
While pushing and holding [PTT], turn power ON to clear
water away from the HM-162E.
•Alow beep tone sounds while [PTT] is pushed and held to
drain water, regardless of volume setting.
The HM-162 never accepts a key operation while the
AquaQuake function is activated.
6 AquaQuake water draining function
(Available depending on the transceiver)
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom HM-162E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom HM-162E in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info