214225
17
Zoom out
Zoom in
Previous page
1/74
Next page
If you are running Windows 98 and you connected the USB cable, the Add New
Hardware Wizard appears again. Drivers must be installed to use the USB
functionality. The Wizard launches three times:
v The first time it detects a USB Composite Device.
v The second time a USB Human Interface Device (for the keyboard).
v The third time it detects a USB Human Interface Device (for the mouse).
Displaying a computer source image
To display a computer source, complete the following procedure:
1. Remove the lens cap.
2. Toggle the power switch on the side of the projector to the on position.
The LED flashes green and the fans start to run. When the lamp comes on, the
start up screen displays and the LED is steady green. It can take a minute for
the image to achieve full brightness.
3. Turn on your computer.
The computer image should appear on the projection screen. If it does not,
press the Computer button on the projector keypad.
If your computer has Windows 98 as its operating system, see “Using the
projector with Windows 98” on page 2-4 regarding the driver setup process.
4. Make sure your laptop external video port is active.
Many laptops do not automatically turn on their external video port when a
projector is connected. Usually a key combination like FN + F7 is used to turn
the external display on and off. Refer to your laptop documentation to learn
your laptop’s key combination.
Adjusting the image
To adjust the image, complete the following procedure:
1. Adjust the height of the projector, if necessary, by pressing the release button to
extend the foot, as shown in Figure 2-8.
2. If necessary, rotate the leveling foot located at the rear of the projector, as
shown in Figure 2-9 on page 2-6.
1 Elevator foot
2 Release button
Figure 2-8. Adjusting the height of the projector
Chapter 2. Setting up the projector 2-5
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ibm ilv 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ibm ilv 300 in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info