214224
17
Zoom out
Zoom in
Previous page
1/66
Next page
5. Turn device ON.
Starting the projector and adjusting the image
Use the following procedure to start the projector and adjust the image.
1. Remove the lens cap.
2. Attach the power cord to the side of the projector, and then into an electrical outlet. It is good practice
to use a surge-protected power strip. Always use the power cord that was included with the projector.
Note: With some computers, the order in which you start the equipment is very important. Most
computers should be turned on last, after all other peripheral devices have been turned on.
Refer to the computer documentation to determine the order.
3. Press the Power button on the top of the projector. The fans start to run, and the LED on the top of
the projector lights green until the startup screen displays. It takes about one minute for the image to
achieve full brightness.
4. If you connected a video player, turn it on.
v The video image is displayed on the projection screen. If it is not, press the Select button on the
keypad or Video button on the remote control to display your video image.
5. Turn on your computer.
Note: The first time you connect your computer to the projector, the computer might display a
message stating that new hardware was found. The Add New Hardware Wizard window
might open. Use the wizard to install the correct device driver for a Plug and Play monitor.
v The computer image is displayed on the projection screen. If it is not, press the Select button on the
keypad or Computer button on the remote to display your computer image.
v Make sure your mobile computer external video port is active; see Appendix C, Portable and
mobile computer activationon page 33 for details.
v If necessary, make adjustments to the image using the projector on-screen menus. To display the
menus, press the Menu button on the keypad or remote control. For more information about the
menus see Using the on-screen menuson page 12.
Turning off the projector
To turn off the projector, press the Power button. If you want to turn the lamp back on, allow 90 seconds
for the lamp to cool. The lamp will not turn on if it is too hot.
Note: To maximize lamp life, allow the projector fan to run for at least five minutes before removing the
power cord.
Chapter 1. Installing the projector 7
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ibm ilm 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ibm ilm 300 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info