214224
13
Zoom out
Zoom in
Previous page
1/66
Next page
Attention:
Do not look directly into the projection lens when the lamp is turned on. The bright light might
harm your eyes.
Attention:
Follow these guidelines when working with the projector.
v Do not block the grills on the projector. Restricting the airflow can cause it to overheat and turn off. If
this happens, you must wait one minute before attempting to start the projector again.
v Handle the projector as you would any other product with glass components. Be especially careful not
to drop it.
v Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this
happens, allow it to reach room temperature before use.
v Transport the projector in a carrying case. See ‘‘Accessories’’ in Appendix A for information on
ordering a case and other accessories for your projector.
Setting up the projector
Before turning on your projector, make sure all connections are made. Use the following procedure to set
up the projector:
1. Place the projector on a flat surface.
v The projector must be within 3 meters (10 feet) of your power source and within 1.8 meters (6 feet)
of your computer.
v If you want to project from behind a translucent screen, set up the projector behind the screen. See
the instructions for Rear projection in System menuon page 18 for instructions on reversing the
image.
2. Position the projector the desired distance from the screen.
v If the image is too big or too small, set the zoom ring to adjust the size or move the projector
forward or backward. Once you have made all connections described in this section, you can make
adjustments. The following illustration shows three projected image sizes. For more information
about image size, see Appendix E, Projected image sizeon page 39.
3.0 ft. (.91m
)
7
.1
ft.
(2
.2
m
)
11.8 ft. (3.6m)
5 ft.
(1.5m)
12 ft.
(3.7m)
20 ft.
(6.1m)
dvi
InFocus
Chapter 1. Installing the projector 3
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ibm ilm 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ibm ilm 300 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info