511748
82
Zoom out
Zoom in
Previous page
1/314
Next page
7.
Install
the
drive
into
the
bay.
Align
the
screw
holes
and
insert
the
two
screws.
8.
Pivot
the
drive
bay
cage
back
into
place.
9.
Each
integrated
drive
electronics
(IDE)
drive
requires
two
cables;
a
four-wire
power
cable
that
connects
to
the
power
supply
and
a
signal
cable
that
connects
to
the
system
board.
You
might
also
have
an
audio
cable
to
connect.
The
steps
to
connect
an
IDE
drive
are
different
depending
on
the
type
of
drive
you
are
connecting.
Locate
the
procedure
below
for
your
drive
connection.
To
connect
an
additional
IDE
hard
disk
drive
1.
You
will
have
to
obtain
a
three-connector,
ATA-100
compatible
signal
cable
to
connect
your
new
hard
disk.
2.
Remove
the
two-connector
cable
from
the
hard
disk
drive.
3.
Locate
the
primary
IDE
connector
on
the
system
board.
One
end
of
the
three-connector
cable
connects
to
the
hard
disk
drive
and
the
other
connects
to
the
system
board.
See
“Types
8305,
8306,
8309,
and
8313”
on
page
45.
4.
Connect
the
extra
connector
in
the
signal
cable
to
the
new
hard
disk
drive.
5.
Your
computer
has
extra
power
connectors
for
additional
drives.
Connect
a
power
connector
to
the
drive.
76
Hardware
Maintenance
Manual
82


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ibm 8310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ibm 8310 in the language / languages: English as an attachment in your email.

The manual is 8,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info