511739
60
Zoom out
Zoom in
Previous page
1/314
Next page
3.
Remove
the
metal
shield
from
the
drive
bay
by
inserting
a
flat-blade
screwdriver
into
one
of
the
slots
and
gently
prying
it
loose.
4.
Make
sure
the
drive
is
set
correctly
as
the
master
device.
Refer
to
the
documentation
that
comes
with
your
CD-ROM
drive
or
DVD-ROM
drive
for
master/slave
jumper
information.
5.
Pivot
the
drive
bay
latch
handle
toward
the
front
of
the
computer
and
then
pivot
the
drive
bay
cage
upward,
as
shown,
until
it
is
latched
in
the
up
position.
6.
Install
the
drive
into
the
bay.
Align
the
screw
holes
and
insert
the
two
screws.
7.
Each
integrated
drive
electronics
(IDE)
drive
requires
two
cables;
a
four-wire
power
cable
that
connects
to
the
power
supply,
and
a
signal
cable
that
connects
to
the
system
board.
To
connect
a
CD-ROM
drive
or
DVD-ROM
drive
to
your
computer,
follow
these
steps:
a.
Locate
the
signal
cable
that
comes
with
your
computer
or
with
the
new
drive.
b.
Locate
the
secondary
IDE
connector
on
the
system
board.
See
“Identifying
parts
on
the
system
board”
on
page
44.
c.
Connect
one
end
of
the
signal
cable
to
the
secondary
IDE
connector
on
the
system
board
and
the
other
to
the
CD-ROM
drive
or
DVD-ROM
drive.
54
Hardware
Maintenance
Manual
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ibm 8301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ibm 8301 in the language / languages: English as an attachment in your email.

The manual is 8,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info