662882

i.safe Mobile IS-MP.1 Manual

5
Zoom out
Zoom in
Previous page
1/20
Next page
EN 5
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
It is recommended that a device which shows or which is suspected of faults and da-
mages is returned i.safe MOBILE GmbH for inspection.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certi cate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the cover of the USB interface has to be closed.
To ensure the IP protection, it has to be ensured that all gaskets are present and
functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the i.safe
PROTECTOR USB-cable or other equipment approved by i.safe MOBILE GmbH.
USB-connections to other equipment are only allowed outside ex-hazardous areas
using the i.safe PROTECTOR USB-cable or other equipment approved by i.safe
MOBILE GmbH.
The device may be charged only at temperatures in between 5 °C … 35 °C.
The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0 or 20.
Only accessories approved by i.safe MOBILE GmbH may be used.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
with a soft cloth gently, and do not scratch the screen.
Charge the device under indoor conditions only.
EN
5
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised if, for example:
Malfunctions occur.
The housing of the device shows damage.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been subjected to excessive loads.
The device has been stored improperly.
The device has been stored improperly.
Markings or labels on the device are illegible.
Markings or labels on the device are illegible.
It is recommended that a device which shows or which is suspected of faults and da-
mages is returned
i.safe MOBILE GmbH
for inspection.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certi cate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the cover of the USB interface has to be closed.
To ensure the IP protection, it has to be ensured that all gaskets are present and
functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the
i.safe
PROTECTOR
USB-cable or other equipment approved by
i.safe MOBILE GmbH
.
USB-connections to other equipment are only allowed outside ex-hazardous areas
using the
i.safe PROTECTOR
USB-cable or other equipment approved by
USB-cable or other equipment approved by
i.safe
i.safe
MOBILE GmbH
.
The device may be charged only at temperatures in between 5 °C … 35 °C.
The device may be charged only at temperatures in between 5 °C … 35 °C.
The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0 or 20.
Only accessories approved by
i.safe MOBILE GmbH
may be used.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails
Do not touch the screen of the device with sharp objects. Dust particles and nails
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
may scratch the screen. Please maintain the screen clean. Remove dust on the screen
with a soft cloth gently, and do not scratch the screen.
Charge the device under indoor conditions only.
Charge the device under indoor conditions only.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for i.safe Mobile IS-MP.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of i.safe Mobile IS-MP.1 in the language / languages: English, German as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info