16
4.5 Keep a proper footing and balance at all times when loading or unloading the mixer.
4.6 NEVER stand on the mixer.
4.7 Serious injury could occur if the mixer is tipped or if the moving parts are unintentionally
touched.
4.8 DO NOT store anything above or near the mixer that anyone might stand on the mixer
to reach them.
4.9 Keep your hands clear of all moving parts.
4.10 DO NOT place any part of your body or any tool in to the drum during operation.
4.11 When operating do not pass hands through the clearance between frame and support
arm or the space between the drum and the support arm.
4.12 ALWAYS work within the rated capacity.
4.13 DO NOT start the drum if the drum is fully loaded.
4.14 DO NOT turn the mixer off if the drum is full.
4.15 DO NOT use the mixer for a purpose for which it was not intended.
4.16 The mixer is not to be towed behind any vehicle.
4.17 NEVER lever the mixer running unattended.
4.18 ALWAYS allow the mixer to come to a complete stop before leaving.
4.19 NEVER open the motor cover before unplugging the mixer.
4.20 Disconnect from the power supply when not in use, before moving, making
adjustments, changing parts, cleaning or working on the mixer.
4.21 Consult technical manual before servicing.
4.22 Clean the mixer immediately after use, keep the mixer clean for best performance.
4.22 DO NOT pour or spray water directly over the motor cover.
4.33 Remove all traces of material from the drum to avoid more material adding to it.
4.34 DO NOT use bricks to clean the drum.
4.35 DO NOT beat on the drum with a shovel, hammer or other tools to break up
accumulations of dried material as this can damage the machine and will not be
covered by warranty.
4.36 The drum can be cleaned using 1” gravel and water for approximately 2 minutes.
4.37 NEVER carry or move the mixer by its power cord or yank it to disconnect from the
socket.
4.38 Extension cords must be no longer than 50 meters in length.
4.39 The wire section must be 1.5mm
2
on 230v to allow sufficient current flow to the motor.
4.40 Improper use of extension cords may cause inefficient operation of the mixer which can
result in overheating or motor damage and not be covered by warranty.
4.41 Only extension cords to H07RN-f specification intended for outdoor use may be used.
4.42 Connections must be made with protected material suitable for outdoor use.
