802226
6
Zoom out
Zoom in
Previous page
1/16
Next page
b) Insert 4 AA powerful batteries into the compartment nd ensure each
battery is in the proper direction.
Low battery and replacement
When power on, the low battery symbol will display once the unit
start to work, and you must replace with new batteries, otherwise the
unit can’ t work.
Battery type and replacement
Please use 4pcs AA identical 1. 5V alkaline batteries.
Do not use the batteries beyond their expiry date. Please remove the
batteries if you do not need to use for long time.
WARNING:
Dispose of the battery in accordance with all federal, state and local
laws. To avoid re and explosion hazard, do not burn or incinerate the
battery.
SETTING MODE
Note:
When use AC adapter, the power of battery won’t be consumed.
When suddenly stop during measurement ( like the plug off from the
outlet by carelessness) , it must be reinserted the plug into the unit.
and restart the measurement.
How to set
1. Start to year:
Press button when power on , the year will be ashing, and then use
button to set year which you want, press button when you conrm the
year, then It will enter into the month and date setting mode
2. Month and date setting
Continue to above step, the screen will display MONTH-DAY and
XX-xx, and keep ashing on month , the digit will increase 1 when
press button @ each time, you could choose from 1 to 12. Press
button when you conrm the month, then it will set the date. Same as
the month setting , each time you press button @ , the digit will keep
changing from 01 to 31. Press button@ when you conrm the date,
then it will enter into the lime setting mode.
3. Time setting:
Continue to above step, the screen will display TIME and XX: XX, and
keep ashing on the digits of hour, the digit will increase 1 when press
button @ each time, you could choose from o to 23. Press button when
you conrm the hour, then the digits of minute start to ash , same
as the hour setting , each lime you press button @ the digits will keep
changing from 00 to 59. Press button when you conrm the minute,
then the total setting mode is completed.
4. Unit setting:
Continue to above step, The unit will be changed when press button@
each lime. Press button <!) when you conrm the unit, then it will enter
into the user setting mode.
PROPER USE OF THE UNIT
Please keep quiet for 5-10 minutes, and avoid eating, drinking
alcohol, smoking, exercising and bathing before taking measurement.
All these factors will inuence the measurement result.
Remove any garment that ts closely to your upper arm.
Always measure on the same arm(normally left).
Take measurement regularly at the same lime of every day,as blood
pressure changes even during the day.
Common factors of wrong measurement
All efforts by the patient to support their arm can increase blood
pressure.
Make sure you are in a comfortable,relax position and do not activate
any of the muscles in the measurement arm during measurement.Use
a cushion for support if necessary.
If the arm artery lies lower or higher than the heart,a false reading will
be obtained.
Note:
Only use clinically approved cuffs!
A loose cuff or a exposed bladder causes false reading.
With repealed measurements ,blood accumulates in the arm which
can lead to false reading.
Consecutive blood pressure measurements should be repealed after
1 minute pause or after the arm has been held up in order to allow
the accumulated blood to ow away.
FITTING THE CUFF
1) Put the cuff on a table atly with the velcro
side down. Pass the end of the cuff through the metal loop so that
a circle is formed. The velcro closer will now be facing outwards
(ignore this step if the cuff has already been prepared) .
2) Push the cuff over the left upper arm so that
the tube points in the direction of the lower arm.
3) Wrap the cuff on the arm as illustrated. Make certain that the lower
edge of the cuff lies approximately 2 to 3 cm above the elbow and
the rubber tube leaves the cuff on the inner side of the arm.
4) Tighten the free end of the cuff and close the cuff by afxing the
velcro.
5). The cuff should be snug on your upper arm so That you can t 2
ngers between the cuff and your upper arm. Any piece of clothing
restricts the arm which must be taken off.
6). Secure the cuff with the velcro closer in such a way that it lies
comfortably and not too tight. Lay your arm on a table (palm
upwards) so that the cuff is at the same height as the heart. Do not
bend the tube.
Note:
If it is not possible to Iii the cuff to your left arm. it can also be placed
on the right. However. all measurements should be made using the
same arm.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hyundai HHA282104 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hyundai HHA282104 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info