6
Instruction manual
USB playback
• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
versions 1.1 and 2.0) up to 8 Gb.
• To use USB drives for MP3 playback, slide
the function switch to CD/MP3 position. Insert
the USB drive into the USB port and press and
hold PLAY/PAUSE/USB button on the unit or
USB button on the RC until the display
shows “USB”.
• All operations with files contained in USB
are the same as operations with MP3 discs.
Always switch off the unit or change
mode to CD before removing a USB flash
drive, to prevent damage to your USB device.
Note: Although this product is fully
compatible with USB 1.1 and 2.0 standard
formats, a small percentage of USB flash
drives might not be readable, due to those
device manufacturers non-compliance with the
full (official) USB standards.
“Dynamic Bass Boost” system
For increased bass at all volume levels,
press BASS button for an emphasized bass
sound. Press the button again to disable the
function.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Accessories
Radio player 1 pc
Power cord 1 pc
Remote controller 1 pc
Instruction manual 1 pc
Warranty card 1 pc
Consumer information 1 pc