755
Maintenance
HEADLIGHT AIMING ADJUSTMENT
Before performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground and
press the front bumper and rear
bumper down several times. Place the
vehicle at a distance of 3,000 mm
(118 in.) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools).
4. Clean the head lights lens and turn on
the headlight (low beam).
5. Open the hood.
6. Draw the vertical line (through the
center of each headlight beam pat-
tern) and the horizontal line (through
the center of each headlight beam
pattern) on the aiming screen.
And then, draw a horizontal parallel
line at 30 mm (1.18 in.) under the hor-
izontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a phillips
screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZONTAL
AIMING.
Adjustment After Headlight
Assembly Replacement
OHR072106L
Vertical aiming
Horizontal
aiming
G290B01HR-1
G290B02HR-1
■ Front view
30mm (1.18 in.)
Horizontal line
Vertical line
H
L
W
Ground line
H
H
Ground
line
“P”
“P”
W
Cut-off line
Cut-off line
Horizontal line
Vertical line
30mm (1.18 in.)
