675897
30
Zoom out
Zoom in
Previous page
1/40
Next page
6.3. Trimmer blade sharpening
When sharpening the blade you MUST wear safety gloves.
6.3.1. Remove the cutting blade from the shield. Remove the blade by undoing the 3 self-
tapping screws (put in a safe place). Place the blade firmly into a vice.
6.3.2. Sharpen blade using a suitable flat file. You MUST maintain the blades original cutting
angle.
6.3.3. Reverse process to refit blade.
6.4. Storage.
If you do not follow these steps, deposit
may arise in the carburetor. This will cause
starting difficulties and may cause
permanent damage.
6.4.1. Perform all the general
maintenance that the maintenance section
of your ‘User Manual’ is recommended.
6.4.2. Clean the outside of the machine,
drive axle, shield and nylon cutting head.
6.4.3. Remove all fuel from the fuel tank.
6.4.4. After all the fuel has been removed
from the fuel tank. Start the engine. Allow
the engine to run in idle until engine stops
alone. This allows the fuel to be removed
from the carburetor.
6.4.5. Allow the engine to cool down for
about five minutes.
6.4.6. Remove the spark plug and pour
1 teaspoon of clean oil into the
combustion chamber. Slowly pull the
starter rope several times to coat internal
components. Replace the spark plug.
6.4.7. Store the machine in a cool, dry
place away from any source of ignition
such as an oil burner, water heater etc.
6.5. Transporting the machine.
6.5.1. When transporting the machine
make sure that no fuel is allowed to leak
out.
6.5.2. DO NOT allow the trimmer/brush
cutter come into contact with persons,
animals and property.
Cord cutter blade
3 x self-tapping
Fixing screws
Cord cutter blade
Page 30
Rev 3 - September 2016
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hyundai 57132 - HYBC5200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hyundai 57132 - HYBC5200 in the language / languages: English as an attachment in your email.

The manual is 3,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info