675902
27
Zoom out
Zoom in
Previous page
1/36
Next page
6.4.1. Cle
aning.
DO NOT hose engine.
Water can damage engine or contaminate the
fuel system.
6.4.1.1. Wipe deck with dry cloth.
6.4.1.2. You can hose under deck by tilting the
mower. Make sure you tilt the machine so that
the air filter is facing up.
6.4.1.3. Dry the machine completely to prevent
any rust forming. You can use a light oil or
silicone spray to prevent rust between.
6.4.2. Storage.
When st
oring the machine make sure it has
been cleaned as in cleaning section 6.4.1.
You can use a light oil or silicone spray to coat
the equipment.
6.4.2.1. The following steps should be taken to
prepare your lawnmower for storage.
6.4.2.2.1. After the final cut of the
season you
must drain the fuel from the fuel tank. Then run
the machine until the engine comes to a stop
this allows the carburetor to be emptied of fuel.
6.4.2.2.2. Clean the mower completely and
make sure all moving parts are lubricated.
6.4.2.2.3. Check the blade to make sure that it is
ready for the following season This will allow
you to get it sharpened correctly. Use a light oil
or silicone spray to help prevent the blade.
6.4.2.2.2.4. Once all work above is carried out
store the machine in a clean and dry place. DO
NOTE store a machine that has not been given
time to fully cool down.
7. TROUBLESHOOTING.
7.1. Engi
ne troubleshooting where necessary
all corrective actions should be carried out by
suitably qualified persons.
7.2. If the starter rope becomes disconnected
from the rope guide on handle, disconnect the
spark plug cap. Depress the blade control
handle and pull the starter rope out from engine
slowly and re- engage in guide. Re connect spark
plug cap.
PROBLEM ENGINE DOES NOT START.
Possible causes;
1. Throttle lever not in the correct position for
the prevailing conditions.
2. Fuel tank is empty.
3. Stale fuel
4. Air filter element is dirty.
5 .Spark plug is loose.
6. Spark plug cap loose or disconnected from
plug.
7. Spark plug gap is incorrect.
8. Carburetor is flooded with fuel.
9. Faulty ignition module.
10. Loose Operator Prescence Control cable.
Possible corrective actions;
1. Move throttle lever to correct position.
2. Fill tank with fuel.
3. Drain carburetor float bowl.
4. Clean air filter element.
5. Tighten spark plug to 25- 30Nm.
6. Make sure spark plug cap is correctly fitted
onto spark plug.
7. Set gap between electrodes at
0.7 to 0.8mm.
8. Remove air filter element and pull starter
rope continuously until carburetor clears.
9. Contact the service dealer.
10. Loose Operator Prescence Control cable.
ENGINE DIFFICULT TO START OR LOSES POWER.
Possible causes;
1. Dirt, water or stale fuel in tank.
2. Vent hole in fuel tank cap is plugged.
3. Air filter element is dirty.
Possible corrective actions;
1. Drain fuel and clean tank. Fill tank with clean,
fresh fuel.
2. Clean or replace fuel tank cap.
3. Clean air filter element.
Page 27
Revison 5 August 2016
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hyundai 57010 - HYM43P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hyundai 57010 - HYM43P in the language / languages: English as an attachment in your email.

The manual is 3,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info