661321
18
Zoom out
Zoom in
Previous page
1/196
Next page
- 16 -
Note: In the case of three-phase models, swapping two phases may cause the electric motors
to run in the reverse direction, which can lead to damage. For this reason, the unit has a
built-in protective device that breaks the circuit if the connection is not correct. If the red LED
above this safety device lights up, you must swap the connections of two of the phase
wires.
3.8 Initial operation
Note: In order to heat the water in the pool (or hot tub), the filter pump must be running
to cause the water to circulate through the heat pump. The heat pump will not start up
if the water is not circulating.
After all connections have been made and checked, carry out the following procedure:
1. Switch on the filter pump. Check for leaks and verify that water is flowing from and to the
swimming pool.
2. Connect power to the heat pump and press the On/Off button on the electronic control
panel. The unit will start up after the time delay expires (see below).
3. After a few minutes, check whether the air blowing out of the unit is cooler.
4. When turn off the filter pump , the unit should also turn off automatically , if not, then adjust
the flow switch.
Model
Voltage (V)
Fuse or
circuit
breaker (A)
Rated current (A)
Wire diameter mm
2
(with max. 15 m length)
HYDRO PRO5
220–240
15
4.1
2x 1.5 + 1.5
HYDRO PRO7
220–240
15
4.7
2x 1.5 + 1.5
HYDRO PRO10
220–240
20
7
2x 2.5 + 2.5
HYDRO PRO13
220–240
25
9.1
2x 2.5 + 2.5
HYDRO PRO18
220–240
40
13.4
2x 6 + 6
HYDRO PRO22
220–240
45
15
2x 6 + 6
HYDRO PRO22T
3x 380
20
6.6
4x 2.5 + 2.5
HYDRO PRO26
220–240
50
17.4
2x 6 + 6
HYDRO PRO26T
3x 380
25
7.7
4x 2.5 + 2.5
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hydro-Pro 26T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hydro-Pro 26T in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 14,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hydro-Pro 26T

Hydro-Pro 26T Usermanual and installation guide - Dutch - 35 pages

Hydro-Pro 26T User Manual - Dutch - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info