571940
56
Zoom out
Zoom in
Previous page
1/60
Next page
56
glass scan then be tilted out and cleaned. Once the glass is clean, lift the door again halfway up, pull out
the top guide latches on the sides, ease the glass pane into place, and lead the guide latches back into
place over the screws.
The inside of the glass pane is best cleaned with damp paper towel dipped in ash. Afterwards, dry with a
clean paper towel. The outside of the glass can be cleaned with ordinary cleaning solvent used to polish
surfaces. We recommend wiping down the window pane when the insert is not in use/cool.
Ash
We recommend removing ash from the combustion chamber with an ash suction device. Make sure you
keep the air slot at the bottom of the rear plate free from ash.
Ash can be disposed of through daily refuse collection. Be aware that embers in the ash can
remain hot up to 24 hours after the fire in the insert has gone out!
MaIntenance
Maintenance
Regularly ensure that the air slit for the pane air rinse function (drawing C, 3) is free of ash and soot
particles. Regularly check to make sure that seals in the door are complete and soft. If not, they should
be replaced. Use only original spare parts.
The insert should be thoroughly cleaned once a year. Ash and soot must be removed from the combus
-
tion chamber. If necessary, lubricate the door lift mechanism with copper grease.
Service inspection
At least once every other year, the insert should receive a thorough, preventative service inspection.
Among other things, the service inspection covers:
• A thorough cleaning of the insert.
• Inspection of the door lift mechanism and lubrication with copper grease if necessary
(drawing B,1).
• Check the spring in the automatic unit and replace if necessary.
• Checking gaskets. Replace gaskets if they are not intact or are no longer soft.
• Inspection of springs for chain drive. Inspection to ensure that the chain drive is equal on both sides,
and that the door closes tightly all the way around.
• Inspection/possible replacement of heat insulation material.
The inspection must be performed by a qualified professional.
Use only original spare parts.
Cleaning
Before chimney sweeping can be performed, the adjustment bar must be set all the way to the left to
prevent soot and ash from entering the automatic control.
Drawing C
Remove the smoke shelf (1). Push the plate forward and lift it up a bit to the side. Tilt one side downward.
The plate is now free and can be removed from the combustion chamber. Lift the steel smoke deflector
plate
(2) off of the hooks so that it can be removed.
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam I30-65 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam I30-65 in the language / languages: English, German, Danish, Swedish, Norwegian as an attachment in your email.

The manual is 1,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam I30-65

Hwam I30-65 User Manual - Dutch, French, Italian, Spanish - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info