571931
50
Zoom out
Zoom in
Previous page
1/60
Next page
50
It is possible to connect several devices to the same chimney. However, it is important to first check the
applicable rules. Contact your local chimney sweeper for the approval of your chimney.
Even a good chimney can function badly if it is not used correctly. Similarly, a bad chimney may function
well if it is used correctly.
Chimney sweeping
To prevent the risk of chimney fires, the chimney must be cleaned every year. The flue duct and the smoke
chamber above the baffle plate must be cleaned together with the chimney. If the chimney’s height makes
cleaning from above impossible, a cleaning hatch must be installed in the chimney.
In case of a chimney fire, close all dampers and call the firefighters. Before any further use, have the
chimney checked by the chimney sweeper.
Test results from nominal test EN 13229:
Nominal heating effect 4.5 kW
Smoke temperature 250°C
Exhaust gas flow 5.9 g/sec.
MountIng and connectIon (draWIng a)
The HWAM I 30/45 consists of a moveable, external brickwork casing, as well as an insert that is pushed
into place and connected once the brickwork casing has been assembled.
The HWAM I 30/45 can be connected in two ways:
1. Mounting and connecting in an existing fireplace.
2. New construction around the insert, possibly including heat ducts to other rooms.
1. Mounting and connecting in an existing fireplace (Drawing A1-A3)
Before mounting the insert in a brick-built fireplace, the regulating damper in the existing chimney must
be removed and the smoke neck, if any, should be widened so that the fire tube from the insert can be
connected directly to the chimney. Any bricks positioned on edge at the bottom of the fireplace should
also be removed.
In advance, decide with a specialist or the chimney sweep where a soot door
(1) should be placed, so
that the fire tube can be cleaned from above while the door of the insert remains closed.
Mounting the smoke pipe (Drawing A1)
First mount the joining flange (2) with a suitable length of fire tubing or flexible tubing (3). Push the
inner pipe into the connector. The inner pipe must be turned so that the handle goes as far as possible
into the connector.
Trim approximately 3 fireproof batts of 50 mm each
(4) so that they fit tightly into the chimney space
and cut a hole in the centre to fit tightly around the tube.
Place the fire tube in the chimney so that the joining flange corresponds to the given measurements.
a. Distance from front edge of the brick hole, if the insert must be flush with the brickwork.
b. Height over the bottom of the insert.
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam I30-45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam I30-45 in the language / languages: English, German, Danish, Swedish, Norwegian as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam I30-45

Hwam I30-45 User Manual - Dutch, French, Italian, Spanish - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info