744549
38
Zoom out
Zoom in
Previous page
1/52
Next page
38
Trouble shooting
The gas pilot will not ignite or stay lit?
Ensure the gas is turned on at the appliance and the meter/cylinder.
Hold in the pilot gas button for at least twenty seconds once the pilot is alight to ensure the
operation of the safety thermocouple valve.
Ensure that the pilot injector is not obstructed or blocked and it is free from any dust or dirt
Ensure that the thermocouple has not been damaged in transit. This is a very delicate Electro-
magnetic device.
On propane, the cylinder could be empty.
The pilot is not burning or performing correctly?
Ensure the pilot fl ame is the correct size for the type of gas. The fl ame should be focused on
the thermocouple probe.
The pilot fl ame will have been set correctly in the factory.
The Main Burner does not seem to be burning correctly?
Ensure adequate gas pressure to the appliance. The pressure can be checked by unscrewing
the pressure test nipple and applying a suitable pressure gauge (i.e. a manometer). Ensure
adequate volume of gas is being used. Once the fi re is burning on maximum, turn off all other
gas appliances in the house and calculate the fuel being burned from the gas meter.
Make sure that the burner is burning correctly. The fl ame should be fairly even across the top
of the burner, before any coals are placed on top.
Servicing instructions
These instructions are intended for use in conjunction with the normal servicing practices that
an installer would normally use.
1. Open the door.
2. Remove the coals/logs carefully and replace any that are damaged or broken.
3. Clean any deposition of lint off the burner. This can be done with a soft brush.
4. Inspect the burner unit and replace the ceramic matt if required.
5. Relay the fi re in line with the instructions “arranging the layout of the coals and logs”.
6. Refi t the door.
Important
This appliance must not be operated without the door fi tted securely, or if the glass is broken
or damaged.
There should be no need to service the burner. If however this is required, a CORGI registered
tter should check the setting pressure at the nozzle on the gas inlet of the burner. The correct
pressure required is stated on the data information plate.
38


Need help? Post your question in this forum.

Forumrules
1

Forum

hwam-carmen-gas

Reset search

  • The seal around the glass door needs sticking back. How is the door held in place, are there hinges? Thanks Submitted on 4-9-2021 at 07:45

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam Carmen gas at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam Carmen gas in the language / languages: English, German, Danish, Swedish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam Carmen gas

Hwam Carmen gas User Manual - Dutch, French, Italian - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info