Manual Hwam 4240 (page 13 of 20) (English)

744535

Zoom out

Zoom in

1/20

Page 13 of 20 pages

The chimney draft is created by the differences in temperature inside and outside the chimney. The higher the

temperature within the chimney, the greater the draft. It is therefore crucial that the chimney is heated well

through before regulating the air supply and thus limiting the combustion in the stove (a brick chimney takes

longer to warm up than a steel chimney). On days where the weather and wind conditions create insufﬁcient

draught inside the chimney, it is even more important to warm up the chimney as quickly as possible. The

trick is to quickly get some ﬂames going. Split the wood into extra ﬁne pieces, use an extra ﬁrelighter, etc.

If the stove has not been used for a longer period, it is important to check that the chimney pipe is not blocked.

It is possible to connect several devices to the same chimney. However, it is important to ﬁrst check the

applicable rules.

Chimney sweeping

To prevent the risk of chimney ﬁres, the chimney must be cleaned every year. The ﬂue duct and the smoke

chamber above the bafﬂe plate must be cleaned together with the chimney. If the chimney is too tall to

be cleaned from above, it must be equipped with a soot door.

In case of a chimney ﬁre, close all dampers and call the ﬁreﬁghters. Before any further use, have the

chimney checked by the chimney sweeper.

FIrIng manual - wood

Your ﬁrst heating session

The lacquer will be fully hardened after the stove has been used, and the door and the ashpan should be

opened very carefully as there will otherwise be a risk that the gaskets will stick to the lacquer. In addi

tion the lacquer may initially give off an unpleasant odour, so make sure that the room is well ventilated.

Tips about fuel

Approved fuel types

The wood burning stove is EN approved for combustion of wood only. It is recommended to use dried

chopped wood with a water content of 12-18%. Stoking a ﬁre with wet wood results in soot, environmental

problems, and a less efﬁcient fuel economy. It is recommended to purchase a hygrometer to continuously

check that the ﬁrewood has the correct moisture content before using it for ﬁring.

Recommended wood types

All types of wood, for instance birch, beech, oak, elm, ash, conifers, and fruit trees can be used as fuel in your

insert. The great difference is not in the fuel value, but in the weight of the wood types per cubic metre.

Beech weighs more per m

of wood than common spruce, for instance. This is why more common spruce

is required, in terms of volume, to obtain an amount of heat similar to that of beech. Heavy types of wood

such as ash, beech, oak and elm are generally not that easy to light up. In addition, they burn more slowly and

give off more embers. Light types of wood such as birch, maple, spruce and pine are more easy to light up.

They burn faster and give off fewer ambers. You may therefore take advantage of the light types of wood for

lighting and use the heavier types of wood to ensure a longer burning time.

Banned fuel types

It is not allowed to stoke a ﬁre with the following: printed matter, plywood, plastic, rubber, ﬂuid fuels,

and rubbish such as milk cartons, lacquered wood or impregnated wood and fossil fuels. The reason that

you should not apply any of the above is that during combustion they develop substances that are health

hazardous and harmful to the environment. These substances could also damage your wood burning stove

and chimney, rendering the product warranty void.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 4240 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 4240

Hwam 4240 User Manual - German - 20 pages

Hwam 4240 User Manual - Dutch - 20 pages

Hwam 4240 User Manual - French - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hwam 4240 Manual

Product: