571903
10
Zoom out
Zoom in
Previous page
1/60
Next page
10
Drawing A
HWAM 3610/3630/3650
Min. distances:
HWAM 3620/3640/3660
Min. distances:
1. Recommendedforbrickwall,back,cm 10 10
2. Recommendedforbrickwall,side,cm 15 10
1. For inflammable wall, back, cm 10 10
2. For inflammable wall, side,cm 40 40
1. To inflammable wall,corner installation,cm 35* 20*
3. Distance to furnishings in front, cm 90 90
*All dimensions in connection with corner installation are only recommendations. Contact your chimney
sweep for a clarification.
Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes
be treated as a flammable wall, in which case we ask you to contact your local chimney sweep or glass
producer to hear at what distance the stove should be kept from glass.
Remember to pay attention to any regulations concerning the required distance between
the wall and smoke pipe.
The distance to a brick wall is set to faciliate the servicing of the HWAM Autopilot IHS
TM
.
Requirements for chimney and smoke pipe
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems. The
stove requires a draft of at least 12 Pa.
The chimney must have a minimum opening equivalent to Ø 15 cm. The chimney opening should always
be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly. Make sure that the
chimney is tight and that no false draft is caused around neither the cover plate, in connection with a
coveredsmokeoutlet,northecleanoutdoorandpipeconnections.Pleasenotethatbentand/orhori-
zontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of the stoves (Drawing B)
B1:HWAM3610,HWAM3620
B2:HWAM3630,HWAM3640
B3:HWAM3650,HWAM3660
1. Smoke shelf. Must be placed on the steel rail and the holder at the front in the middle.
2. The baffle plate is suspended on three hooks beneath the top plate. One of the hooks has an additional
flap that is bent upwards as protection during transport. This flap should be removed with the help
of a screwdriver before installation.
3. The rear smoke outlet has been closed at the factory by screwing a plate over it and it is therefore
hidden behind the rear plate.
4. Removablerearplate.Thismustalwaysbemountedifthestoveisplacednexttoacombustiblewall.
5. Loose heat shield. This must always be mounted if the stove is placed next to a combustible wall.
6. Loose heat shield beneath the ash pan. Can be used as a lid when the ash pan is removed for emptying.
Connection to chimney
All the stoves have both rear and top smoke outlet.
that can be connected to an approved steel chimney on top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bentand/orhorizontalsmokepipeswillreducetheeffectofthechimneydraft.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3650 in the language / languages: English as an attachment in your email.

The manual is 7,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3650

Hwam 3650 User Manual - German - 40 pages

Hwam 3650 User Manual - Dutch, French - 17 pages

Hwam 3650 User Manual - Italian, Spanish - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info