571936
17
Zoom out
Zoom in
Previous page
1/60
Next page
17
Recommended dimensions
Thedimensionsofthefuelareimportanttogoodcombustion.Thedimensionsshouldbeasfollows:
Fuel type Length in cm Diameter in cm
Wood for kindling a fire (finely chopped) 25-33 2-5
Chopped wood 25-33 7-9
Special lighting guide for wood-burning stoves with soapstone cladding
Soapstone is a natural product, which needs to get used to the changes in temperature. For this reason
you should be very careful the first times you light up the stove. It is recommended that you follow the
procedureoutlinedbelow:
1. The first stoking (soapstone)
Place split kindling with a diameter of 2-5 cm the equivalent of approx. two pieces of wood (a maximum
of two kilos) in the stove. Place two fire-lighters in between the top layers of kindling. Press the remote
control twice to activate the symbol of lighting up. Light up the fire-lighters and close the stove door.
Adjust the temperature selection mechanism on the remote control to level one. Let the fire burn out
and do not restoke even if there is a restoking alarm. When the fire has died out completely, the door
must be opened and stay open while the stove cools down to room temperature.
2. The second stoking (soapstone)
Place split kindling with a diameter of 2-5 cm the equivalent of approx. two pieces of wood (a maximum
of two kilos) in the stove. Place two fire-lighters in between the top layers of kindling. Press the remote
control twice to activate the symbol of lighting up. Light up the fire-lighters and close the stove door.
Adjust the temperature selection mechanism on the remote control to level two. When there is a restok-
ing alarm, you should restoke. Fill the combustion chamber half way up with dry wood of a diameter of
approx. 7-9 cm. Let the fire burn and let the stove cool down to room temperature before the next lighting.
3. The third stoking (soapstone)
Repeatthesecondstoking,butusemorewoodthistimeandadjustthetemperatureselectiononthe
remote control to level three. Let the fire burn and allow the stove to cool down after the fire has died out.
Lighting Up
A successful combustion process requires that the wood is lit in the right way. A cold stove and a cold
chimney challenge the combustion process. It is important to achieve a high flue gas temperature quickly.
Only at temperatures around 350° C will environmentally friendly combustion take place.
Place two pieces of wood (5-8 cm in diameter) horizontally in the bottom of the
combustion compartment. Place 5-8 pieces of kindling randomly on top. Place
two fire-lighters in between the top layers of kindling. Press the remote control
twice to activate the symbol of lighting up. Light up the fire-lighters and close the
stove door. Adjust the temperature selection mechanism on the remote control
to the desired heat level.
If the desired flue gas temperature of 350° C has not been achieved within 15 minutes, the remote control
will activate a re-stoking alarm even if there still might be wood and flames in the combustion compart-
ment. The re-stoking alarm can seem misplaced, but it is activated because the temperature climbs too
slowly.Re-stokingwithsmallpiecesofkindlingwoodcanoftenresultinafasterincreaseintemperature.
HWAM Autopilot IHS
TM
closes all three air dampers when the stove is in standby mode. This prevents
hot air from the room to enter the chimney (heat loss). This might on the other hand result in a very
cold chimney when the stove is lit. In certain cases it is necessary to assist the draught in the chimney
byburningacoupleofnewspaperpagesontopofthewoodreadytobelit.Readmoreonwww.hwam.
com about the function of the chimney.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3620 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3620 in the language / languages: English as an attachment in your email.

The manual is 7,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3620

Hwam 3620 User Manual - German - 40 pages

Hwam 3620 User Manual - Dutch, French - 17 pages

Hwam 3620 User Manual - Italian, Spanish - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info