477575
46
Zoom out
Zoom in
Previous page
1/72
Next page
46
5
Switching off the engine
Move the gas control to ”. Disconnect the cutting unit
by moving the connect/disconnect lever downwards. Lift up
the cutting unit and turn the ignition key to “OFF” position.
Allow the engine to idle for 1-2 minutes to cool down before
switching off after a hard work.
Abstellen des Motors
Gashebel nach unten auf “ ” führen. Mähaggregat durch
Abwärtsführen des Aggregatschalthebels auskuppeln. Mäh-
aggregat anheben und den Zündschlüssel auf “OFF” drehen.
Den Motor 1-2 Minuten im Leerlauf arbeiten lassen, damit
dieser nach längerem Mähbetrieb abkühlen kann.
Arrêt du moteur
Amener la commande des gaz vers le bas en position de
ralenti " ". Débrayer les lames en abaissant le levier de
commande d'embrayage des lames. Relever le carter de coupe
et amener la clé de contact sur la position "OFF". Après des
travaux diffi ciles, laisser le moteur tourner au ralenti pendant
1 à 2 minutes pour qu'il refroidisse avant de l'arrêter.
Parada del motor
Lleve el acelerador hacia abajo hasta la posición ”. De-
sacople el equipo de corte llevando hacia abajo la palanca
de acoplamiento/desacoplamiento. Levante el equipo de
corte y ponga la llave de encendido en la posición “OFF”
(apagado). Deje funcionar el motor en ralentí 1-2 minutos
para que se enfríe antes de pararlo después de un tiempo
de uso intenso.
Arresto del motore
Portare il comando del gas su (lento). Portare la leva di
azionamento del dispositivo di taglio su “disinserito”, verso il
basso. Sollevare il tagliaerba e girare la chiave su “off”. Far
girare un paio di minuti il motore al minimo per raffreddarlo
prima di spengerlo defi nitivamente dopo un pesante turno
di lavoro.
Het stoppen van de motor
Breng de gashendel naar beneden tot stand “ ”. Schakel
de maaikast uit, door de aan/uitschakelhendel naar beneden
te brengen. Verhoog de maaikast en zet de contactsleutel
in positie “OFF”. Laat de motor 1-2 minuten stationair lopen
om af te koelen, voordat deze uitgezet wordt.
WARNING!
Do not leave the ignition key in the machine when not in use
to prevent children and other unauthorized persons starting
the en gine.
WARNUNG!
Den Zündschlüssel niemals im Zündschloß sitzen lassen,
wenn die Machine unbeaufsichtigt verlassen wird, damit
nicht Kinder und unbefugte Personen den Motor anlassen
können.
ATTENTION!
Ne jamais laisser la clé de contact sur la ma chine lorsqu'elle
reste sans surveillance afi n d'éviter que des enfants ou
d'autres personnes non autorisées ne puissent démarrer
le moteur.
ADVERTENCIA!
Nunca deje la llave de encendido en la máquina sin vigilancia,
a fi n de evitar aue niños u otras personas ajenas puedan
arrancar el motor.
PERICOLO!
Prima di lasciare la macchina, togliere sempre la chiave.
WAARSCHUWING!
Laat nooit de contactsleutel er in zitten, wanneer de ma chine
onbemand wordt achtergelaten, om te voorkomen dat kin-
deren en onbevoegden de motor starten.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna YTH151 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna YTH151 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info