733945

Husqvarna TC 138L Manual

85
Zoom out
Zoom in
Previous page
1/108
Next page
85
6
M
V
V
R
R
Twist 180 Degrees
Um 180 Grad drehen
Tournez à 180 degrés
592980201
To Replace Mower Drive Belt
MOWER DRIVE BELT REMOVAL
1. Park tractor on a level surface. En gage parking brake.
2. Lower attachment lift lever to its lowest position.
3. Remove any dirt or grass clippings which may have ac-
cumulated around mandrels and entire upper deck surface.
4. Remove belt from clutch pulley (M), mandrel pulley (R),
and all idler pulleys (V).
MOWER DRIVE BELT INSTALLATION
1. Install belt around both mandrel pulleys (R) and around
idler pulleys (V) as shown.
2. Install belt onto clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower pul-
ley grooves.
NOTE: Arrows on belt routing image represent a twist in the
belt in order to correctly align with pulleys. Narrow side of
belt always mate to pulleys, wide side of belt always mate
to flat idlers.
3. Raise attachment lift lever to highest position.
Austauschen des Antriebsriemens des Mähers
ENTFERNEN DES ANTRIEBSRIEMENS DES MÄHERS
1. Parken Sie den Traktor auf einer ebenen Fläche. Legen Sie
die Handbremse ein.
2. Drücken Sie den Hebel für den Anhängerlift auf seine
niedrigste Stellung.
3. Entfernen Sie Schmutz oder Grasreste, die sich vielleicht
rund um die Wellen und auf der ganzen Fläche des Ober-
decks angesammelt haben.
4. Den Riemen von der Kupplungsscheibe (M), der Spindel-
scheibe (R) und allen Umlenkrollen (V) abziehen.
INSTALLIEREN DES ANTRIEBSRIEMENS DES MÄHERS
1. Legen Sie den Riemen rund um die beiden Wellenscheiben
(R) und um die Freilaufscheiben (V) wie abgebildet.
2. Nun legen Sie den Riemen um die Kupplungsscheibe (M).
WICHTIG: Prüfen Sie den richtigen Verlauf des Riemens in
allen Triebradrinnen des Mähers.
Sustituir la correa de transmisión cortacésped
QUITAR LA CORREA DE TRANSMISIÓN DEL CORTA-
CÉSPED
1. Aparcar el tractor en una superficie nivelada. Poner el freno
de estacionamiento.
2. Bajar la palanca elevadora hasta su posición más baja.
3. Quitar cualquier suciedad o grasa que puede haberse
acumulado alrededor de los mandriles y toda la superficie
superior de la cubierta.
4. Quite la correa de la polea del embrague (M), la correa del
mandril (R) y las poleas tensoras (V).
INSTALACIÓN DE LA CORREA DE TRANSMISIÓN DEL
CORTACÉSPED
1. Instalar la correa alrededor de las dos poleas del mandril
(R) y alrededor de las poleas-guías (V) como mostrado.
2. Instalar la correa en la polea de embrague (M).
IMPORTANTE: Controlar que la correa gire bien en todas las
ranuras de la polea del cortacésped.
NOTA: Las flechas de la imagen de colocación de la correa
representan un giro de la correa para poder alinearla cor-
rectamente con las poleas. El lado estrecho de la correa se
corresponde siempre con las poleas, mientras que el lado ancho
de la correa siempre se corresponde con los tensores planos.
3. Levantar la palanca elevadora hasta la posición más alta.
HINWEIS: Die Pfeile auf der Riemenverlaufsabbildung zeigen
eine Verdrehung, um die exakte Ausrichtung mit den Riemen-
scheiben zu gewährleisten. Die schmale Seite des Riemens
passt immer zu den Riemenscheiben, die breite Seite passt
immer zu den flachen Umlenkrollen.
3. Heben Sie den Anhängerlifthebel auf seine höchste Stellung.
… 85 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna TC 138L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna TC 138L in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info