579242

Husqvarna TC 138 Manual

93
Zoom out
Zoom in
Previous page
1/104
Next page
93
6
MAINTENANCE - TRANSAXLE
The fan and cooling fins of transmission should be kept clean
to assure proper cooling.
Do not attempt to clean fan or transmission while engine is
running or while the transmission is hot.
• Inspect cooling fan to be sure fan blades are intact and
clean.
• Inspect cooling fins for dirt, grass clippings and other
materials.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid maintenance
is not required. Should the transaxle ever leak or require
servicing, contact your nearest authorized service center/
department.
WARTUNG - GETRIEBE
Das Gebläse und die Kühlrippen des Getriebes sollten sauber
gehalten werden, um einwandfreie Kühlung zu gewährleisten.
Nicht versuchen, das Gebläse oder das Getriebe zu reinigen,
solange der Motor läuft bzw. solange das Getriebe heiß ist.
• Das Kühlgebläse untersuchen und sicherstellen, daß die
Gebläseflügel unbeschädigt und sauber sind.
• Die Kühlrippen auf Schmutz, Schnittgut oder anderen
Unrat untersuchen.
GETRIEBE-PUMPENFLÜSSIGKEIT
Das Getriebe wurde vom Werk abgedichtet und normaler-
weise sollte in Bezug auf die Flüssigkeit keine Wartung
notwendig sein. Sollte das Getriebe undicht werden oder
aus anderen Gründen Wartung benötigen, sollte die örtliche
Vertragswerkstatt bzw. Vertrags-Kundendienstabteilung
aufgesucht werden.
ENTRETIEN - TRANSMISSION
Le ventilateur et les ailettes de refroidissement du carter de
transmission doivent être maintenus propres pour assurer
un refroidissement correct.
Ne pas essayer de nettoyer le ventilateur ou la transmission
tant que le moteur est en fonctionnement ou que la transms-
sion est chaude.
• Vérifier le ventilateur de refroidissement afin de s'assurer
que ses pales sont en bon état et propres.
• Vérifier l'état des ailettes de refroidissement du carter
de transmission qui ne doivent pas être couvertes de
poussière, de résidus de coupe ou d'autres matériaux.
Afin d'éviter des fuites éventuelles au niveau des joints,
ne pas utiliser d'air comprimé ou de nettoyeur à haute
pression pour nettoyer les ailettes.
FLUIDE DE LA POMPE HYDRAULIQUE
La transmission est scellée en usine et il n'est donc pas néces-
saire de contrôler ou de parfaire le niveau du fluide. Dans le
cas où la transmission présenterait une fuite ou nécessiterait
une intervention, contacter un réparateur agréé de la marque
de la transmission.
MANTENIMIENTO - TRANSEJE
Las aletas de enfriamiento y el ventilador de la trans mi sión
tienen que mantenerse limpios para asegurar el enfriamiento
adecuado.
No trate de limpiar el ventilador o la transmisión cuando el
motor esté funcionando o mientras la transmisión esté caliente.
• Inspeccione el ventilador de enfriamiento para ase gu rar se
que las aspas del ventilador estén intactas y limpias. Para
impredir daños a los sellos, no use un rocidador de aire
compresado o de alta pressión para limpiar las aletas de
enfriamiento.
• Inspeccione las aletas de enfriamiento para ve ri fi car si
hay mugre, recortes de césped u otros ma te ria les.
NIVEL DEL FLUIDO DE LA BOMBA DEL TRANSEJE
El transeje ha sido sellado en la fábrica y el man te ni mien to
del fluido no es necesario para la vida del transeje. En el
caso de que el transeje se filtrase o ne ce si ta se servicio, haga
el favor de ponerse en con tac to con su centro/de par ta men to
de servicio autorizado más cer ca no.
MANUTENZIONE - ASSE-TRAZIONE
Il ventilatore e le alette di raffreddamento della trasmissione
devono essere tenuti puliti per assicurare il giusto raffred-
damento.
Non tentare di pulire il ventilatore o la trasmissione quando
il motore è in funzione o quando la trasmissione è calda.
• Controllare il ventilatore per accertare che le lame siano
intatte e pulite.
• Controllare le alette di raffreddamento per verificare che
non vi siano tracce di impurità, di erba o di altri materiali.
POMPA FLUIDO - TRASMISSIONE E TRAZIONE
ANTERIORE
La trasmissione e la trazione anteriore sono state sigillate in
fabbrica e pertanto non richiedono operazioni di intervento
concernenti i fluidi. Se la trasmissione e la trazione anteriore
dovessero perdere o necessitare di intervento tecnico, con-
tattare il più vicino centro di assistenza tecnico autorizzato.
ONDERHOUD - TRANSMISSIEKOELING
De ventilator en koelribben van de transmissie moeten schoon
gehouden worden om voore de juiste koeling te zorgen.
Tracht niet de ventilator of de transmissie te reinigen terwijl
de motor draait of terwijl de transmissie heet is.
• Controleer de koelventilator om u ervan te overtuigen dat
de bladen intact en schoon zijn.
• Controleer de koelribben op vuil, gras en ander materiaal.
TRANSMISSIEPOMPVLOEISTOF
De transmissie is in de fabriek verzegeld en vloeistofonder-
houd is niet nodig. Als de transmissie ooit mocht lekken of
een onderhoudsbeurt nodig hebben, dient u een bevoegd
servicecentrum of afdeling te raadplegen.
… 93 …


Need help? Post your question in this forum.

Forumrules
1

Forum

husqvarna-tc-138

Reset search

  • Hi, on my TC 138 there is a slight thumping noise which disappears when I engage the brake. Any ideas please? Submitted on 27-6-2022 at 13:55

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna TC 138 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna TC 138 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info