Manual Husqvarna TC 138 (page 23 of 104) (English, German, Dutch, French, Italian, Spanish)

579242

Zoom out

Zoom in

1/104

• Using a ½ inch (13mm) wrench or socket, completely

remove the silver ground screw (1) and set aside.

DO NOT discard, it will be reused later.

• On BLACK cable (2), slide protective sleeve (4) back to

expose terminal end (5).

• Reinstall previously removed silver ground screw (1)

through exposed terminal end (5) and into location from

where silver ground screw (1) was removed.

• Tighten securely. Visually inspect cable to ensure no

part of protective sleeve (4) is trapped under the head of

the ground screw. If needed, loosen silver ground screw,

reposition sleeve and re-tighten screw.

BATTERIE ANSCHLIESSEN

1. Masseschraube (Silber)

2. SCHWARZES Kabel (-)

3. ROTES Kabel (+)

4. Schutzmanschette

5. Polende

WARNUNG: Die Nichtbeachtung der Installationsan-

weisungen kann zu Funkenbildung, Lichtbogen oder

offenen Flammen führen, was zu schweren Körperver-

letzungen oder Sachbeschädigungen führen kann.

WARNUNG: Stellen Sie sicher, dass sich der Zündschalter

des Traktors in der AUS-Position (OFF) befindet und der

Zündschlüssel ABGEZOGEN ist.

• Suchen Sie die silberne Masseschraube (1) auf der

rechten Platte des Traktors, über dem rechten Hinterrad.

• Suchen Sie das SCHWARZE und ROTE Batteriekabel

im gleichen Bereich. Stellen Sie sicher, dass das ROTE

Kabel (3) am Anlassmagnetschalter angeschlossen

ist, und dass das SCHWARZE Kabel (2) nicht mit der

Schutzmanschette (4) verbunden ist, die das Polende

(5) vollständig bedeckt.

• Lösen Sie mit einem ½ Zoll (13mm) Schraubenschlüssel

die silberne Masseschraube (1) vollständig, und legen

Sie diese für später beiseite. NICHT ENTSORGEN, sie

wird später noch benötigt.

• Schieben Sie am SCHWARZEN Kabel (2) die Schutzman-

schette (4) zurück, um das Polende (5) frei zu legen.

• Setzen Sie die zuvor gelöste silberne Masseschraube (1)

durch das frei liegende Polende (5) an der Stelle ein, an der

Sie zuvor die silberne Masseschraube (1) gelöst hatten.

• Fest anziehen. Eine Sichtprüfung des Kabels durchführen,

um sicherzustellen, dass sich kein Teil der Schutzman-

schette (4) unter dem Kopf der Masseschraube verfangen

hat. Lockern Sie bei Bedarf die Masseschraube, setzen Sie

die Manschette korrekt auf und ziehen Sie die Schraube

wieder fest.

CONNECTER LA BATTERIE

1. Vis de mise à la masse (argentée)

2. Câble NOIR (-)

3. Câble ROUGE (+)

4. Manchon de protection

5. Extrémité cosse

AVERTISSEMENT: Le non-respect des instructions

d’installation peut être à l’origine d’une production

d’étincelles, d’arcs électriques ou de flammes nues

susceptibles de provoquer des blessures corporelles

graves ou des dommages matériels.

AVERTISSEMENT: S’assurer que le commutateur d’allu-

mage du tracteur est sur la position d’arrêt (OFF) et que

la clé de contact est RETIRÉE.

CONNECT BATTERY

1. Ground screw (Silver)

2. BLACK Cable (-)

3. RED Cable (+)

4. Protective sleeve

5. Terminal end

WARNING: Not following installation instructions can

result in sparks, arcing or open flames which could lead

to serious personal injury or property damage.

WARNING: Ensure tractor ignition switch is in the OFF

position and ignition key is REMOVED.

• Locate silver ground screw (1) on right side plate of tractor,

above right rear tire.

• Locate BLACK and RED battery cables in same area.

Ensure RED cable (3) is securely attached to the starter

solenoid and the BLACK cable (2) is not attached with

protective sleeve (4) completely covering terminal end (5).

Hi, on my TC 138 there is a slight thumping noise which disappears when I engage the brake. Any ideas please? Submitted on 27-6-2022 at 13:55
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna TC 138 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,29 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna TC 138 Manual

Product: