579232
40
Zoom out
Zoom in
Previous page
1/84
Next page
40
BEFORE STARTING THE ENGINE
Check engine oil level (Q)
The engine on your snow thrower has been shipped, from the factory, already
filled with oil.
1. Check engine oil with snow thrower on level ground.
2. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw
tight, wait for a few seconds, remove and read oil level. If necessary, add
oil until “FULL” mark on dipstick is reached. Do not overfill.
To change engine oil, see “TO CHANGE ENGINE OIL” in the Main te nance
section of this manual.
Add gasoline (R)
Fill fuel tank to bottom of tank filler neck. Do not overfill. Use fresh, clean,
regular unleaded gasoline with a minimum of 87 octane. Do not mix oil
with gasoline. Purchase fuel in quantities that can be used within 30 days
to assure fuel freshness.
WARNING: Wipe off any spilled oil or fuel. Do not store, spill or use
gasoline near an open flame.
VOR DEM MOTORSTART
Überprüfen des ölstandes (Q)
Der Motor Ihrer Schneefräse wurde bereits ab Fabrik mit Öl gefüllt geliefert.
1. Überprüfen Sie den Ölstand mit der Schneefräse auf ebenerdigem Untergrund.
2. Nehmen Sie die Ölverschlusskappe mit Messstab ab und wischen Sie den Messstab sauber. Stecken Sie den Messstab
wieder in den Öltank und schrauben sie die Verschlusskappe fest zu. Warten Sie ein paar Sekunden, nehmen Sie die
Kappe erneut ab, und lesen Sie den Ölstand ab. Wenn nötig, füllen Sie Öl nach, bis Markierung “FULL” am Messstab er-
reicht ist. Nicht zu viel Öl einfüllen.
Ölwechsel siehe “MOTORÖLWECHSEL” im Abschnitt Wartung dieses Handbuchs.
Benzin nachtanken (R)
Füllen Sie den Benzintank bis zum unteren Rand des Betankungsstutzens. Nicht zu viel Benzin einfüllen. Verwenden Sie
frisches, sauberes, unverbleites Normalbenzin mit einer Mindestoktanzahl von 87. Ben zin nie mit Öl vermischen. Um die
Frische des Kraftstoffes zu gewährleisten, kaufen Sie nur soviel, wie innerhalb von 30 Tagen aufgebraucht werden kann.
WARNUNG: Verschüttetes Öl oder Benzin entfernen. Benzin nie in Nähe von offenem Feuer lagern, verschütten
oder verwenden.
AVANT DE METTRE LE MOTEUR EN MARCHE
Vérifiez le niveau d’huile du moteur (Q)
Le moteur de votre souffleuse a été expédié, de l’usine, déjà rempli d’huile.
1. Vérifiez l’huile du moteur en plaçant la souffleuse au niveau du sol.
2. Enlevez le bouchon/jauge d’huile du graisseur et essuyez-le, réinsérez la jauge d’huile et vissez fortement, attendez quelques
secondes, enlevez et lisez le niveau d’huile. Si nécessaire, ajoutez de l’huile jusqu’à ce que la marque “PLEIN” sur la jauge
d’huile soit atteinte. Ne faites pas un remplissage excessif.
Pour changer l’huile de moteur, voir “CHANGER L’HUILE DE MOTEUR” dans la section Entretien de ce manuel.
Ajoutez de l’essence (R)
Remplissez le réservoir à essence jusqu’au bas du col de remplissage du réservoir. Ne faites pas un remplissage excessif.
Utilisez de l’essence naturelle fraîche, propre, régulière sans plomb avec un minimum de 87 octanes. Ne mélangez pas
d’huile avec l’essence. Achetez le carburant en quantités pouvant être utilisées dans les trente jours suivant l’achat pour
s’assurer de sa fraîcheur.
ATTENTION: Essuyez soigneusement toute dispersion d’huile ou de carburant. Ne rangez, dispersez ni n’utilisez
d’essence près d’une flamme nue.
E
Q
R
U
S
D
C
V
T
F
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna ST 327T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna ST 327T in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info