579230

Husqvarna ST 327P Manual

72
Zoom out
Zoom in
Previous page
1/80
Next page
72
PROBLEM CAUSE CORRECTION
Does not start 1. Fuel shut-off valve (if so equipped) in
“OFF” position.
1. Turn fuel shut-off valve to “OPEN” position.
2. Safety ignition key is not inserted. 2. Insert safety ignition key.
3. Out of fuel. 3. Fill fuel tank.
4. Throttle in “STOP” position (or ON/
OFF switch in “OFF” position).
4. Move throttle to “FAST” position (or ON/OFF switch to “ON”
position).
5. Choke in “OFF” position. 5. Move to “FULL” position.
6. Primer not depressed. 6. Prime as instructed in the Operation section of this manual.
7. Engine is flooded. 7. Wait a few minutes before restarting, DO NOT prime.
8. Spark plug wire is disconnected. 8. Connect wire to spark plug.
9. Bad spark plug. 9. Replace spark plug.
10. Stale fuel. 10. Drain tank and refill with fresh, clean fuel.
11. Water in fuel. 11. Drain fuel tank and carburetor and refill tank with fresh gasoline.
Loss of power 1. Spark plug wire loose. 1. Reconnect spark plug wire.
2. Throwing too much snow. 2. Reduce speed and width of swath.
3. Fuel tank cap is covered with ice or
snow.
3. Remove ice and snow on and around fuel tank cap.
4. Dirty or clogged muffler. 4. Clean or replace muffler.
Engine idles or
runs roughly
1. Choke is in FULL position. 1. Move choke to OFF position.
2. Blockage in fuel line. 2. Clean fuel line.
3. Stale fuel. 3. Empty fuel tank & carburetor, refill with fresh, clean gasoline.
4. Water in fuel. 4. Empty fuel tank & carburetor, refill with fresh, clean gasoline.
5. Carburetor is in need of replacing. 5. Contact an authorized service center/department.
Excessive
vibration
1. Loose parts or damaged augers or
impeller.
1. Tighten all fasteners. Replace damaged parts. If vibration re-
mains, contact an authorized service center/department.
Recoil starter is
hard to pull
1. Frozen recoil starter. 1. See “IF RECOIL STARTER HAS FROZEN” in the Operation sec-
tion of this manual.
Loss of traction
drive / slowing of
drive speed
1. Worn belt. 1. Adjust drive cable per maintenance procedures.
2. Drive belt is off of pulley. 2. Check / reinstall Drive belt.
3. Drive belt is worn. 3. Check / replace Drive belt.
Loss of snow dis-
charge or slowing
of snow discharge
1. Auger belt is off of pulley. 1. Check / reinstall auger belt.
2. Auger belt is worn. 2. Check / replace auger belt.
3. Clogged discharge chute. 3. Clean snow chute.
4. Augers / impeller jammed. 4. Remove debris or foreign object from augers / impeller.
Lights not On 1. Motor not running. 1. Start engine.
2. Loose wire connection. 2. Check wire connections at engine and light.
3. LED burnt out. 3. Replace LED light module. (Individual LEDs are not replaceable)
… 72 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna ST 327P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna ST 327P in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info