477694
45
Zoom out
Zoom in
Previous page
1/68
Next page
45
0.030 inch
(0.76 mm)
12
13
15
15
13
14
16
12. Unplug electrical wires (12) on back of ignition switch (13).
13. Pull tube (14) off the back of the primer bulb (15).
14. Lift rear upper cover and lay it to the side of the unit.
IMPORTANT: The recoil rope will still be attached to the upper
cover.
IMPORTANT: Inspect the fuel tank, fuel lines, primer bulb, spark
plug wire, and electrical wires for cracks or damage.
15. Disconnect the spark plug (16) wire from the spark plug.
16. Clean around the spark plug.
17. Remove the spark plug from the cylinder head.
IMPORTANT: Replace a cracked, fouled, or dirty spark plug. Do
not clean the electrodes because grit entering the cylinder can
damage the engine.
18. Set the gap on the plug to 0.030 inch (0.76 mm).
19. Install the spark plug and torque it to 20–22 ft-lb
(27–30 N-m).
20. Connect the spark plug wire (16) to the spark plug .
21. Reattach primer bulb tube (14) to primer bulb (15) and elec-
trical wires (12) on back ignition switch (13) of rear upper
cover.
22. Set rear upper cover (11) in place so the two screw holes
line up with the rear lower cover and side covers .
23. Reattach two screws (10) through the rear covers and into
the clip on the side cover.
24. Remove top oil fill cap (6).
25. Set top cover (8) in place and snap three top cover clips (9)
into the rear upper cover (11).
26. Reinstall top oil fill cap (6).
27. Reinstall two screws (10) in the side covers that attach to
the clips on the top cover.
28. Reinstall two screws (4) in the plenum (5) that attach to the
top cover (7).
29. Reinstall discharge chute (1) with the hardware removed in
step 5.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Sneeuwmachine ST 121E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Sneeuwmachine ST 121E in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 18,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info