477694
21
Zoom out
Zoom in
Previous page
1/68
Next page
21
Prüfen des Ölstands im Motor
1. Stellen Sie die Schneefräse auf einer waagrechten
Fläche ab.
2. Reinigen Sie den Bereich um den Ölmessstab.
HINWEIS: Die Position des Ölmessstabs variiert je nach
Motortyp.
3. Schrauben Sie je nach Modell den Ölmessstab mit
Öltankdeckel seitlich am Gerät ab bzw. ziehen Sie den
Ölmessstab oben am Gerät heraus (1) und wischen
Sie den Stab sauber.
Checking the Engine Oil Level
1. Move the snowthrower to a level surface.
2. Clean around the dipstick.
NOTE: Dipstick location may vary depending on engine
type.
3. Remove either side mounted filler cap dipstick or high
oil fill dipstick (1) and wipe it clean.
4. Führen Sie den Ölmessstab in den Einfüllstutzen ein
und drehen Sie ihn so weit wie möglich im Uhrzei-
gersinn. Ziehen Sie den Ölmessstab wieder heraus,
indem Sie ihn gegen den Uhrzeigersinn drehen.
5. Füllen Sie empfohlenes Öl ein, bis der Ölstand die
Markierung „FULL“ am Ölmessstab erreicht.
6. Schrauben Sie den Ölmessstab mit Öltankdeckel
dann wieder fest zu bzw. stecken Sie den Ölmessstab
wieder zurück an die ursprüngliche Position.
HINWEIS: Wenn der Motor mit zu niedrigem Ölstand
läuft, kann es zu Motorschäden kommen. Prüfen Sie
daher vor dem Starten des Motors immer den Ölstand.
HINWEIS: Wenn der Motor mit zu hohem Ölstand
läuft, kann es zu Motorschäden und zu starker
Rauchentwicklung in den Abgasen kommen. Prüfen Sie
daher vor dem Starten des Motors immer den Ölstand.
4. Insert the dipstick into the filler neck and turn clockwise
until fully seated. Then remove the dipstick by turning
it counter-clockwise.
5. Fill oil to "FULL" on dipstick with the recommended
oil.
6. Securely screw in the oil filler cap/dipstick.
NOTE: Running the engine with a low oil level can cause
engine damage. Always check the engine oil before start
up.
NOTE: Running the engine with too much oil may cause
engine damage and excess smoke in the exhaust.
Always check the engine oil level before start up.
1
1
1
1
1
1
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Sneeuwmachine ST 121E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Sneeuwmachine ST 121E in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 18,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info