518159
15
Zoom out
Zoom in
Previous page
1/64
Next page
Instruction book Rose
15
The presser foot pressure is adjusted
with the dial on the front of the
machine. Normal setting is 4. The
higher the number the more
pressure on the fabric. Knit and Soft
fabrics should be sewn at low
pressure.
Presser foot lever
The presser foot is raised and
lowered with the presser foot lever.
The presser foot must be lowered
when sewing. The machine will not
start if the presser foot is in the
raised position.
By raising the presser foot lever as
far as it goes and holding it there,
the lift height of the presser foot can
be increased by several millimeters.
Presser foot pressure
Changing the presser
foot
!
Switch off the main switch.
1. Make sure that the needle is in
the highest position. Pull the
presser foot down and towards
you.
2. Line up the cross pin on the foot
between the spring and the
presser foot ankle. Press back
until the foot snaps into place.
Procedures
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Rose 605 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Rose 605 in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info