518134
16
Zoom out
Zoom in
Previous page
1/44
Next page
14
Learn your Platinum 770
Presser Foot J
This foot is used for overcasting, seam
and overcasting, i.e. stitches which have
a stitch width of 5.0 and 5.5 mm. Stitches
form over the pin which prevents
puckering at the edge of the fabric.
Sensor Buttonhole Foot
When connected to the machine it
measures buttonhole length and sews
the buttonhole size that has been entered
into the machine. The middle mark gives
a 9/16'' (15 mm) buttoning edge.
Read more about different optional
presser feet in the Accessory User’s Guide.
Changing the Presser Foot
Switch off the main switch.
1. Make sure that the needle is in the
highest position. Pull the presser
foot towards you.
2. Line up the cross pin on the foot
between the spring and the presser
foot ankle. Press back until the foot
snaps into place.
Presser Foot Pressure (a)
The presser foot pressure is adjusted
with the dial found under the lid on
your Platinum 770. Normal setting is
around four. The higher the number the
more pressure on the fabric. Knit and
soft fabrics should be sewn at lower
pressure.
Presser Foot Lever (b)
The presser foot is raised and lowered
with the presser foot lever. The presser
foot must be lowered when sewing.
By raising the presser foot lever as
far as it goes and press it upwards, the
lift height of the presser foot can be
increased by several millimeters.
a
b
2.1.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Platinum 770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Platinum 770 in the language / languages: English as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info