517444
10
Zoom out
Zoom in
Previous page
1/34
Next page
10
Attaching Thread Stand
Your Platinum
TM
3000 comes equipped with a 4 spool thread stand. The thread stand can be used
to hold additional thread such as; bobbin thread, so you can wind bobbins at the same time you are
quilting. It is recommend that the thread stand telescoping pole be extended fully in order for the
thread to ow evenly and smoothly.
1. Locate the 2 screws on the machine next to the cable cover. Loosen screws, but do NOT
remove, so that thread stand can slide over screws (g. 18).
2. Slide thread stand over the screws and tighten screws to hold stand in place.
3. Place the telescoping thread tree into the hole in the center of the thread stand. Use the supplied
screw and washer to secure the thread tree to the underside of the thread stand.
4. Extend the telescoping thread tree to its highest position (g. 19)
Connect to Power Supply
1. Plug in the power cable to the power outlet located at the back of the machine (g. 20).
2. Plug in the encoder cables into the identied “encoder” ports located at the back of the machine
(g. 21).
Thread Stand
Fig. 18 Fig. 19
Fig. 20 Fig. 21
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Platinum 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Platinum 3000 in the language / languages: English as an attachment in your email.

The manual is 1,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info