579227

Husqvarna LT141 Manual

57
Zoom out
Zoom in
Previous page
1/72
Next page
57
5. Remove the retainer springs (5), (6), (7) and axles.
6. Pull the lever for lifting/lowering the cutting unit back-
wards.
7. Pull out the cutting unit from the machine.
IMPORTANT: If an attachment other than the mower deck is
to be mounted on the tractor, remove the front links and hook
the clutch spring into square hole in frame (8).
5. Die Federklammern (5), (6), (7) und die jeweiligen Bolzen
ausbauen.
6. Hebel für Heben/Senken des Mähdecks zurückziehen.
7. Mähdeck aus ber Maschine herausziehen.
WICHTIG: Wenn statt dem Mähwerk ein anderes Zubehörteil
am Traktor angebracht werden soll, so sind die vorderen
Verbindungsstücke abzunehmen und die Kupplungsfeder ist
in das eckige Loch des Rahmens (8) einzusetzen.
6
Assembly of the cutting unit
• Push in the cutting unit under the machine. The ejector
opening should be to the right.
• Assemble in the reverse order to dismantling.
Einbau des Mähdecks
• Mähdecks unter den Traktor schieben. Die Auswurfoffnung
muß nach rechts.
• Der Einbau erfolgt in umgekehrter Reihenfolge.
Mise en place du carter de coupe
• Pousser le carter de coupe sous le tracteur. Le déflecteur
du canal d'éjection doit se trouver du côté droit.
• La mise en place se fait dans l'ordre inverse de celui de
la dépose.
Montaje de la unidad de corte
• Introducir la unidad de corte debajo de la máquina. La
abertura de expulsión ha de estar hacia la derecha.
• El montaje se hace en orden inverso al desmontaje.
Montaggio del piatto di taglio
• Ricollocare il piatto sotto la macchina. L'apertura di scarico
dell'erba deve restare a destra.
• Procedere in ordine inverso.
Monteren van de maaikast
• Schuif de maaikast onder de machine. De uitwerp-opening
is naar rechts gericht.
• Het monteren vindt in omgekeerde volgorde van het
demonteren.
5. Retirer les épingles (5), (6) et (7) et leur cheville re spec-
tive.
6. Tirer vers l'arrière le levier de commande de relevage du
carter de coupe.
7. Sortir le carter de coupe de sous le tracteur.
ATTENTION : Si un outil (accessoire), autre que le carter
de coupe, doit être monté sur le tracteur, retirer les biellettes
de relevage avant et accrocher le ressort de la commande
d'embrayage des lames dans le trou carré du châssis (8).
5. Quitar los resortes (5), (6), (7) y los ejes respectivos.
6. Tirar hacia atrás de la palanca para la elevación y de-
scenso de la unidad de corte.
7. Extraer la unidad de corte de la máquina.
IMPORTANTE: Si cualquier otro accesorio qur no sea la
segadora tiene que ser montado en el tractor, se deben re-
mover los brazos de suspensión del lado derecho y del lado
izquierdo y el puntal de suspensión delantero (8).
5. Togliere le coppiglie (5), (6), (7) e i relativi perni.
6. Tirare all’indietro la leva di sollevamento/abbassamento
del piatto di taglio.
7. Staccare il piatto dalla macchina.
ATTENZIONE: Se un accessorio diverso dal piano di taglio
viene montato sul trattore, rimuovere le articolazioni ante-
riori e agganciare la molla della frizione al foro quadrato nel
telaio (8).
5. Verwijder de haarpinveren (5), (6), (7) en resp. assen.
6. Zet de hendel voor verhogen/verlagen van de maaikast
naar achteren.
7. Trek de maaikast van de machine af.
BELANGRIJK: Indien er een ander aanzetstuk dan het
maaidek op de trekker gemonteerd moet worden, verwijder
dan de voorste verbindingen en haak de veer van de aandri-
jfkoppeling in het vierkante gat in de frame (8).
02844
5
6
7
8
… 57 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna LT141 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LT141 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info