733939
597
Zoom out
Zoom in
Previous page
1/604
Next page
故障排除
蓄电池
电池上的 LED 可能的故障 可能的步骤
绿色 LED 闪烁 电池电压过低 给电池充电。请参阅
为电池充电在第 594 页上
错误 LED 闪烁 电池电量不足 给电池充电。请参阅
蓄电池在第 597 页上
工作环境温度过高或过低 在 -10°C 至 40°C 之间的温度下使用电池。
过压 检查电源电压是否与产品标牌上的电压一致。
从电池充电器中取出电池。等待 5 秒钟,然后再次
尝试为电池充电。如果问题仍然存在,请联系经授
权的保养厂。
错误 LED 亮起 电池电压差过大 (1V) 请联系获得批准的保养厂。
电池充电器
电池充电器上的 LED 可能的故障 可能的步骤
错误 LED 闪烁 工作环境温度过高或过低 在 5°C 至 40°C 之间的温度下使用电池充电器。
错误 LED 亮起 请联系获得批准的保养厂
控制面板
错误代码(闪烁次
数)
可能的故障 可能的步骤
1 变速器电机过热。 让本产品冷却。确保变速器上没有草。必要时
清洁变速器盖。
5 电机速度下降过多,电机停止。 清洁刀盘并增加修剪高度。请参阅
设置修剪高
度在第 594 页上
。如果故障仍然存在,请联
系经授权的保养厂。
8 电池电量不足。 给电池充电。请参阅
为电池充电在第 594 页
9 电池故障或电池无信号。 将电池正确装入本产品,并检查电池接头。如
果电池上的故障 LED 闪烁,请参见
蓄电池在
第 594 页上
10 电机控制过热。 停止电机并等待,直到电机冷却。
其它错误 如果出现其他错误,请拔下安全钥匙,取下电池,并联系经授权的保养厂。
运输、存放和废弃处理
介绍
警告: 为防止运输过程中意外启动,向上拉
安全钥匙,取下电池,然后等待至少 5 秒
钟。
将产品置于运输位置 (LC 551iV)
1. 松开下部旋钮。
2. 将旋钮转至本产品的左侧和右侧凹槽的下端。 (图 31)
3. 向前折叠手柄。 (图 68)
4. 拆下集草袋。
1336 - 003 - 17.12.2019 597
597


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna LC 551iV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 551iV in the language / languages: All languages as an attachment in your email.

The manual is 8,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info