Manual Husqvarna LC 347iVX (page 17 of 576) (All languages)

733923

Zoom out

Zoom in

1/576

1. Move the cutting height lever down to decrease the

cutting height.

2. Move the cutting height lever up to increase the

cutting height. (Fig. 33)

CAUTION: Do not set the cutting height too

low. The blades can hit the ground if the

surface of the lawn is not level.

Battery

WARNING: Before you use the battery, you

must read and understand the safety

chapter. You must also read and understand

the operator's manual for the battery and the

battery charger.

Battery status

The display shows the remaining battery capacity and if

there are problems with the battery. The battery capacity

is shown for 5 seconds after the product is switched off

or the battery indicator button is pressed. The warning

symbol on the battery is on when an error has occurred.

See

Battery on page 20

(Fig. 34)

LED lights

Battery status

All LEDs are lit Fully charged (75-100%)

LED 1, LED 2, LED 3 are

lit

The battery is 50%-75%

charged

LED 1, LED 2 are lit The battery is 25%-50%

charged

LED 1 is lit The battery is 0%-25%

charged.

LED 1 flashes The battery is empty.

Charge the battery.

To charge the battery

Charge the battery before the first use. The battery is

only 30% charged when supplied to the customer.

Note:

The battery charger must be connected to the

voltage and frequency specified on the rating plate.

The battery does not charge if the battery temperature is

above 50°C. The battery charger decreases the

temperature of the battery before it starts to charge.

1. Connect one end of the power cord for the battery

charger into the socket of the battery charger.

2. Connect the other end of the power cord for the

battery charger in an grounded mains socket. The

LED on the battery charger flashes green one time.

(Fig. 35)

3. Put the battery in the battery charger. The green light

on the charger comes on when the battery is

correctly connected to the battery charger. (Fig. 36)

4. When all LEDs on the battery have come on the

battery is fully charged. Charge the battery for

maximum 24 hours.

5. To disconnect the battery charger from the mains

socket, pull the plug, not the power cord.

6. Remove the battery from the battery charger.

Battery charging status

A Husqvarna Li-ion battery can be charged or used at all

charging levels. The battery is not damaged. A fully

charged battery will not decrease its charge when the

battery is left in the charger.

LED display Charging status

LED 1 flashes 0%-25%

LED 1 is lit, LED 2 flashes 25%-50%

LED 1, LED 2 are lit, LED

3 flashes

50%-75%

LED 1, LED 2, LED 3 are

lit, LED 4 flashes

75%-100%

LED 1, LED 2, LED 3,

LED 4 are lit

Fully charged

To start the product

1. Open the battery lid.

2. Put a charged battery in 1 of the battery holders. For

longer operation time, put a second charged battery

in the other battery holder.

3. Turn the safety key to 1. (Fig. 22)

4. Stay behind the product.

5. Push the ON/OFF button (A) on the control panel.

The display comes on. The battery indicator (B)

shows the battery charge of the 2 batteries. The

number of the battery that operates is shown

adjacent to the battery indicator. For models

LC 347iVX, LC 353iVX, the display also shows the

set speed. (Fig. 37)

6. Loosen the start inhibitor. (Fig. 24)

7. Push the motor brake handle in the direction of the

handlebar. (Fig. 38)

To use the drive on the wheels

(LC 347iVX, LC 353iVX)

• Pull the drive bail in the direction of the handlebar to

start the drive. (Fig. 39)

• Push + and - on the control panel to set the drive

speed in 4 steps. (Fig. 40)

• Release the drive bail to disengage the drive, for

example when you go near an obstacle.

890 - 002 - 21.12.2018

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 347iVX in the language / languages: All languages as an attachment in your email.

The manual is 6,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna LC 347iVX Manual

Product: