510456

Husqvarna H-CLASS E10 Manual

16
Zoom out
Zoom in
Previous page
1/32
Next page
16
THREADING THE UPPER THREAD
Threading is simple but
it is important to thread
correctly to prevent
sewing problems could
result.
- Start by raising the
needle to its highest
point (1), and also
raise the presser foot
to release the tension
discs. (2)
Attention:
For safety, it is strongly
suggested you turn
off the power before
threading.
- Lift up the spool pin. Place the spool
of thread on the holder with the thread
coming off the spool as shown. For
small thread spools, place small side of
spool holder next to spool. (3)
- Draw thread from spool through the
upper thread guide. (4)
- Guide thread around thread guide
(5) pulling thread through pre-tension
spring as illustrated.
- Thread tension disks by leading thread
down in right channel and up in left
channel (6). During this process it is
helpful to hold the thread between the
spool and thread guide (4).
- At the top pull thread from right to left
through the slotted eye of the take-up
lever and then down again. (7)
- Place thread behind the thin wire
needle clamp guide (8) and then down
to the needle eye and thread from front
to back.
- Pull about 6-8 inches of thread under
the presser foot to the back. Trim
thread to length with built in thread
cutter. (9)
… 16 …


Need help? Post your question in this forum.

Forumrules
1

Forum

husqvarna-h-class-e10

Reset search

  • My dog feed does not appear high enough. How do I adjust this. My stitching on the machine is to small even when it's set at 4 stitch length on my machine.
    I already cleaned the dogfeed.
    Thanks Submitted on 14-5-2022 at 21:42

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna H-CLASS E10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna H-CLASS E10 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna H-CLASS E10

Husqvarna H-CLASS E10 User Manual - German - 32 pages

Husqvarna H-CLASS E10 User Manual - Dutch - 32 pages

Husqvarna H-CLASS E10 User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info