517448

Husqvarna H-Class 200S Manual

58
Zoom out
Zoom in
Previous page
1/64
Next page
56
REPLACING THE CUTTER
Replace the Moving cutter if it becomes blunt. A spare cutter can be found in your accessories.
NOTE: You should not need to replace the xed cutter which is made of a special hard alloy material.
Remove the power cord plug from the power supply outlet.
Remove the stitch nger.
1. Open the working table. Using the wrench, losing the screen and take out the Moving
cutter.
2. Lower the cutter diring arm to the middle position by turning the cutter release knob
toward you. In this position, set the replacement cutter in position and secure it with
the screw. ENSURE THAT THE EDGE OF THE MOVING CUTTER (1) IS
APPROXIMATELY 0.5 mm BELOW THE SURFACE OF THE FIXED CUTTER (2).
DISENGAGING MOVING CUTTER
If you want to sew without cutting, open the working table and disengage the Moving cutter
by pushing the cutter release knob to the left and turning it toward you until the cutter snaps
into the lowest position.
Ensure that fabric edge is not wider than overedge width selected or upper looper and needle
can be damaged.
CHANGING THE LIGHT BULB
Disconnect from power supply before removing face cover.
Remove the face cover screw and take off the face cover.
1. Push up the bulb slightly and turn counterclockwise.
2. Insert the new bulb (15 W), push up and turn clockwise.
Illustration
*I: Screw
*II: Stitch nger
*III: Moving cutter
*IV: Cutter release knob
*V: Face cover
*VI: Face cover screw
*VII: Light bulb
3. CARING FOR YOUR MACHINE
1
2
*
VII
*
V
*
VI
*
III
*
I
*
II
*
IV
15 W
HClass_200s_EN.indd 56 2010-11-19 09:20:55
… 58 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna H-Class 200S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna H-Class 200S in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info