517448
3
Zoom out
Zoom in
Previous page
1/64
Next page
CAUTION - Moving parts
To reduce risk of injury, switch off before servicing. Close
cover before operating machine.
SAVE THESE
INSTRUCTIONS
This product is for household use, or equivalent.
FOOT CONTROL (USA & Canada only)
Use Model YC-483E with this sewing machine.
POLARIZED PLUGS CAUTION
(USA & Canada only)
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to t in a polarized outlet only one way. If the plug
does not t fully in the outlet, reverse the plug. If it still does
not t, contact a qualied electrician to install the proper
outlet. Do not modify the plug in any way.
This appliance complies with EEC Directive 2004/108/
EC covering the electromagnetic compatibility.
Please note that on disposal, this product must be
safely recycled in accordance with relevant National
legislation relating to electrical/ electronic products.
If in doubt please contact your retailer for guidance.
We reserve the right to change the machine equipment
and the assortment of accessories without prior notice, or
make modications to the performance or design. Such
modications, however, will always be to the benet of the
user and the product.
INTELLECTUAL PROPERTY
VIKING, KEEPING THE WORLD SEWING &
Design, and INSPIRA are trademarks of KSIN
Luxembourg II, S.ar.l.
HUSQVARNA and the “crowned H-mark” are trademarks of
Husqvarna AB. All trademarks are used under license by VSM
Group AB.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be followed, including the following.
Read all instructions before using this sewing machine.
DANGER- To reduce the risk of electric shock:
This sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric
outlet immediately after using and before cleaning.
Always unplug before replacing light bulb. Replace bulb with same type rated 15 watts.
WARNING- To reduce the risk of burns, re, electric shock, or
injury to persons:
Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used by or near children.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Use this sewing machine only for its intended use as described in this manual. Use only attachments recommended by the
manufacturer as contained in this manual.
Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water. Return the sewing machine to the nearest authorized dealer or service center for
examination, repair, electrical or mechanical adjustment.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied persons in
order to avoid a hazard.
Never operate the sewing machine with any air openings blocked. Keep ventilation openings of the sewing machine and foot
control free from the accumulation of lint, dust, and loose cloth.
Never drop or insert any object into any opening.
Indoors use only.
Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
To disconnect, turn switch to the off („0“) position, then remove plug from outlet.
Switch off or unplug the appliance when leaving it unattended, unplug the appliance before carrying out maintenance or
replacing lamps.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Keep ngers away from all moving parts. Special care is required around the sewing machine needle.
Never sew with a damaged needle plate as this can cause needle to break.
Do not use bent needles.
Do not pull or push fabric while stitching. It may deect the needle causing it to break.
Switch the sewing machine off (“0”) when making any adjustments in the needle area, such as threading needle, changing
needle, threading looper, or changing presser foot, etc.
Always unplug sewing machine from the electrical outlet when removing covers, lubricating, or when making any other user
servicing adjustments mentioned in the instruction manual.
To avoid electrical shock never put the machine nor the mains cable or mains plug into water or other liquids.
Attention the following to avoid injury:
- Unplug the foot controller of the appliance when leaving it unattended:
- Unplug the foot controller of the appliance before carrying out any maintenance.
HClass_200s_EN.indd 1 2010-11-19 09:20:32
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna H-Class 200S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna H-Class 200S in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info