518047
23
Zoom out
Zoom in
Previous page
1/48
Next page
2. SET UP
21
WIND THE BOBBIN
4. Push the bobbin to the right.
5. Hold the thread end and press the foot
control. After a few turns of the bobbin,
cut off the thread end. When the bobbin
is full it will stop rotating. Push the
bobbin winder to the left and remove the
bobbin. Cut off the thread.
Place the Bobbin in the Machine
Turn off the main switch
1. Make sure that the needle is fully
raised before inserting or removing
the bobbin. Open the bobbin cover by
moving the release button to the right
(A). Remove the cover (B).
2. Place the bobbin in the bobbin case
so that the thread is running in a
counterclockwise direction.
3. Pull the thread though the slit and pull it
towards the left into the tension.
4. Pull the thread so that you have about
6 inches (15cm) of thread. Replace the
bobbin cover plate.
1.
4.
3.
2.
B
A
C
B
A
1. Pull the vertical spool pin up (A). Place a
large spool cap on the spool pin and place
the thread on the spool pin.
2. Bring the thread under the thread tension
disk (B) and around clockwise.
3. Insert the thread though the hole in the
bobbin from the inside to the outside.
Place the bobbin on the bobbin winder
spindle with the free end of the thread at
the top.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Emerald 183 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Emerald 183 in the language / languages: English as an attachment in your email.

The manual is 8,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Emerald 183

Husqvarna Emerald 183 User Manual - German - 48 pages

Husqvarna Emerald 183 User Manual - Dutch - 48 pages

Husqvarna Emerald 183 User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info