585401

Husqvarna CTH160 Manual

78
Zoom out
Zoom in
Previous page
1/84
Next page
78
TRANSAXLE COOLING
The fan and cooling fins of transmission should be kept clean
to assure proper cooling.
Do not attempt to clean fan or transmission while engine is
running or while the transmission is hot.
• Inspect cooling fan to be sure fan blades are intact and
clean.
• Inspect cooling fins for dirt, grass clippings and other
materials.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid mainte
nance is not required. Should the transaxle ever leak or
require servicing, contact your nearest authorized service
center/department.
TRANSACHSEN-KÜHLUNG
Das Gebläse unde die Kühlriippen des Getriebes sollten
sauber gehalten werden, um einwandfreie Kühlung zu
gewährleisten.
Nicht versuchen, das Gebläse oder das Getriebe zu reinigen,
solange der Motor läuft bzw. solange das Getrieb heiß ist.
• Das Kühlgebläse untersuchen und sicherstellen, daß
die Gebläseflügel unbeschädigt und sauber sind.
• Die Kühlrippen auf Schmutz, Schnittgut oder anderen
Unrat untersuchen.
TRANSACHSEN-PUMPENFLÜSSIGKEIT
Die Transachse wurde vom Werk abgedichtet und
normalerweise sollte in Bezug auf die Flüssigkeit keine
Wartung notwendig sein. Sollte die Transachse undicht
werden oder aus anderen Gründen Wartung benötigen,
sollte die örliche Vertragswerkstatt bzw. Vertrags-
Kundendienstabteilung aufgesucht werden.
REFROIDISSEMENT DE LA TRANSMISSION
Le ventilateur et les ailettes de refroidissement de la trans-
mission devraient être conservees propres pour assurer le
refroidissement correct.
N'essayez pas de nettoyer le ventilateur ou la transmission
pendant que le moteur fonctionne ou pendant que la trans-
mission soit chaude.
• Inspectez le ventilateur de refroidissement pour s'assurer
que les lames de ventilateur soient propres et intactes.
• Inspectez les ailettes de refroidissement pour la saleté,
l'herbe coupée et les autres matéraux. Pour empêcher
l'avarie aux joints d'eetanchéité, n'utilisez pas l'air
comprimé ou le pulvérisateur à haute pression pour
nettoyer les ailettes de refroidissement.
FLUIDE DE LA POMPE DE LA TRANSMISSION
La transmission a été scellé à l'usine et l'entretien de fluide
n'est pas exigee pour la durabilité de la transmission. Si la
transmission devrait avoir une fuite ou demande de la
réparation, contactez votree centre d'entretien autorisé le
plus proche.
ENFRIAMIENTO DEL TRANSEJE
Las aletas de enfriamiento y el ventilador de la transmisión
tienen que mantenerse limpios para asegurar el enfriamiento
adecuado.
No trate de limpiar el ventilador o la transmisión cuando el
motor esté funcionando o mientras la transmisión esté
caliente.
• Inspeccione el ventilador de enfriamiento para asegu-
rarse que las aspas del ventilador estén intactas y
limpias. Para impredir daños a los sellos, no use un
rocidador de aire compresado o de alta pressión para
limpiar las aletas de enfriamiento.
• Inspeccione las aletas de enfriamiento para verificar si
hay mugre, recortes de césped u otros materiales.
NIVEL DEL FLUIDO DE LA BOMBA DEL
TRANSEJE
El transeje ha sido sellado en la fábrica y el mantenimiento
del fluido no es necesario para la vida del transeje. En el caso
de que el transeje se filtrase o necesitase servicio, haga el
favor de ponerse en contacto con su centro/departamento de
servicio autorizado más cercano.
RAFFREDDAMENTO ASSE-TRAZIONE
Il ventilatore e le alette di raffreddamento della trasmissione
devono essere tenuti puliti per assicurare il giusto
raffreddamento.
Non tentare di pulire il ventilatore o la trasmissione quando
il motore è in funzione o quando la trasmissione è calda.
• Controllare il ventilatore per accertare che le lame siano
intatte e pulite.
• Controllare le alette di raffreddamento per verificare che
non vi siano tracce di impurità, di erba o di altri materiali.
POMPA FLUIDO -- TRASMISSIONE E TRAZIONE
ANTERIORE
La trasmissione e la trazione anteriore sono state sigillate in
fabbrica e pertanto non richiedono operazioni di intervento
concernenti i fluidi. Se la trasmissione e la trazione anteriore
dovessero perdere o necessitare di intervento tecnico,
contattare il più vicino centro di assistenza tecnico autorizzato.
TRANSMISSIEKOELING
De ventilator en koelribben van de transmissie moeten
schoon gehouden worden om voore de juiste koeling te
zorgen.
Tracht niet de ventilator of de transmissie te reinigen terwijl
de motor draait of terwijl de transmissie heet is.
• Controleer de koelventilator om u ervan te overtuigen dat
de bladen intact en schoon zijn.
• Controleer de koelribben op vuil, gras en ander materiaal.
TRANSMISSIEPOMPVLOEISTOF
De transmissie is in de fabriek verzegeld en
vloeistofonderhoud is niet nodig. Als de transmissie ooit
mocht lekken of een onderhoudsbeurt nodig hebben, dient
u een bevoegd servicecentrum of -afdeling te raadplegen.
66
66
6
NL
Eng
F
Esp
Downloaded from www.Manualslib.com manuals search engine
… 78 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna CTH160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna CTH160 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info