819065

Husqvarna Ceora 546 EPOS - 2023 Manual

43
Zoom out
Zoom in
Previous page
1/56
Next page
7.3 Information and warning messages
The information messages in the table below are shown in the
Messages
menu in the Husqvarna Fleet Services™
app. Speak to your approved servicing dealer if the same message shows frequently.
Message Cause Action
Cutting system imbalance
The product senses vibrations in the cut-
ting disc.
Examine the blades and screws for dam-
ages and wear. Make sure that all blades
are correctly installed and that there is
only one blade attached in each position
on the blade disc.
Connectivity problem
Problem with the Automower® Connect
module.
Restart the product. Disable Automower®
Connect in the app and enable it again.
Wait 1 hour and try again. If the problem
stays, speak to your local approved serv-
icing dealer.
Wrong PIN code
An incorrect PIN code was entered. 5
tries are permitted, and the product is
then blocked for a period of time.
Enter the correct PIN code. If the PIN
code is incorrect, use the web address in
the app to send the PIN code to your reg-
istered e-mail address. If you have not
registered the e-mail address, speak to
your approved servicing dealer.
GPS navigation problem
Temporary electronic or firmware related
problem in the product.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
Ultrasonic problem
The ultrasonic sensor is dirty or blocked. Clean the ultrasonic sensor.
Temporary electronic or firmware related
problem in the product.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
7.4 LED indicator lamps on the charging station
For a fully functional installation, the indicator lamps in the charging station must show a solid or flashing green light. If
another color shows, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, speak to your approved servicing dealer.
Light Status
Green solid light Good signals.
Green flashing light The signals are good and
ECO mode
is activated. Refer to
ECO mode on page 25
.
Red flashing light Interruption in the charging station’s antenna. Speak to your approved servicing
dealer.
Red solid light Fault in the circuit board or incorrect power supply in the charging station. The
fault must be correct by an authorized service technician. Speak to your approved
servicing dealer.
1691 - 006 - 09.01.2023 Troubleshooting - 43
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Ceora 546 EPOS - 2023 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Ceora 546 EPOS - 2023 in the language / languages: English as an attachment in your email.

The manual is 14.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Ceora 546 EPOS - 2023

Husqvarna Ceora 546 EPOS - 2023 User Manual - German - 60 pages

Husqvarna Ceora 546 EPOS - 2023 User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info