644636
85
Zoom out
Zoom in
Previous page
1/100
Next page
English - 83
TROUBLE SHOOTING
9.2 Info Messages
A number of fault messages are listed below that can be shown on the display on the robotic lawnmower. It is
recommended to contact your dealer if the same message appears often. Check that the installation is performed as
described in the Operator's Manual. Then contact your local dealer.
Message Cause Action
Low battery
The robotic lawnmower can not nd
the charging station.
Make sure the charging station and the guide wire
are installed as instructed, see 3 Installation on
page 16.
The guide wire is broken or not
connected.
Find out where the break is and rectify it.
The battery is spent.
Contact your local dealer to test or possibly replace
the battery.
Charging station antenna is defective.
Check if the indicator lamp in the charging station
ashes red. Refer to 9.3 Indicator Lamp in
Charging Station page 84.
Settings restored
Conrmation that Reset all user
settings has been carried out.
This is normal. No action required.
Limited cutting height
range
The maximum and minimum position
of the cutting height adjustment is
limited.
Check that there no grass or other objects are
blocking the blade disc from moving up or down.
Carry out a cutting height calibration via the
Settings > Cutting height menu.
Contact your local dealer if this message appears
often.
Unexpected cutting
height adj
The cutting height adjustment is
altered without a request from the
robotic lawnmower.
Carry out a cutting height calibration via the
Settings > Cutting height menu.
Contact your local dealer if this message appears
often.
Guide 1 not found
Guide 2 not found
Guide 3 not found
The guide wire is not connected to the
charging station
Check that the guide wire connector is properly
connected to the charging station, see 3.6
Installation of Guide Wire on page 28.
Break in the guide wire
Find out where the break is. Replace the damaged
section of the guide wire with a new loop wire and
splice using an original coupler.
The guide wire is not connected to the
boundary loop.
Make sure the guide wire is properly connected to
the boundary wire, see 3.6 Installation of Guide Wire
on page 28. Splice with the original connector.
GPS navigation
problem
Not applicable for Automower® 420.
Problem with the GPS assisted
navigation equipment.
Contact your local dealer if this message appears
often.
Weak GPS signal
Not applicable for Automower® 420.
The GPS signal is weak for the current
working area. GPS assisted navigation
cannot be used.
If the message appears often, turn off the GPS
assisted navigation and instead use the manual
settings for Lawn coverage, see Installation on
page 78.
Guide calibration failed
The robotic lawnmower has failed
while calibrating the guide wire.
Make sure the guide wires are installed as
instructed, see 3.6 Installation of Guide Wire on
page 28.
Guide calibration
accomplished
The robotic lawnmower has calibrated
the guide wire.
No action required
1157866-26,420,430X,450X,EN_160314.indd 83 2016-03-14 17:00:04
85


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna AUTOMOWER 450X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna AUTOMOWER 450X in the language / languages: English as an attachment in your email.

The manual is 14,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna AUTOMOWER 450X

Husqvarna AUTOMOWER 450X User Manual - English - 152 pages

Husqvarna AUTOMOWER 450X User Manual - German - 104 pages

Husqvarna AUTOMOWER 450X User Manual - Dutch - 100 pages

Husqvarna AUTOMOWER 450X User Manual - French - 104 pages

Husqvarna AUTOMOWER 450X User Manual - Italian, Portuguese, Spanish - 152 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info