819081

Husqvarna Automower 450X NERA - 2023 Manual

22
Zoom out
Zoom in
Previous page
1/48
Next page
charging station. You can set the charging station signal
to
min
,
avg
or
max
.
Note: Husqvarna recommends to set the charging
station signal to
max
. It is usually better to move the
charging station, than to decrease the range of the
charging station signal.
4.4.1.2 Follow guide wire and boundary wire
The time interval can be set for when the product starts
to follow the boundary wire and guide wire to find the
charging station.
4.4.2 Lawn coverage
4.4.2.1 GPS assisted navigation
The product has
GPS Assisted Navigation
that helps
the product to select the most optimal operation. This
function is enabled from the factory. If you want to do
manual settings for your lawn, disable the
GPS Assisted
Navigation
and make settings for
Area 1-5
. Disable
the
GPS Assisted Navigation
if you want to use the
Systematic Passage Mowing
function and make settings
for
Area 1-5
. Refer to
Settings for Area 1-5 on page 22
.
4.4.2.2 Settings for Area 1-5
Use this function if the work area includes remote
parts that are connected with narrow passages to keep
a satisfactorily cut work area. The
Lawn Coverage
function is used to cut remote parts of the work area.
The
Systematic Passage Mowing
function is used to
cut in narrow passages. A guide wire must be installed
to use these functions. You can set a maximum of 5
remote areas where the product starts to cut.
The
Systematic Passage Mowing
function is applicable
for narrow passages of 60 cm - 1.5 m / 23 in. - 4.9
ft. width. The product moves in a pattern to cut the
full passage width. The product starts the
Systematic
Passage Mowing
at the set distance from the charging
station. When the product is at the end of the narrow
passage, the product continues to cut the work area as
usual.
You can set the product to follow the guide wire to the
set specified distance before it starts to cut.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
C
B
Each area can be enabled or disabled. Use the
Test
function to measure the distance from the charging
station to where the product must start to cut. Refer to
To measure the distance from the charging station on
page 22
.
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it moves out
from the charging station. If the guide wire is less than
300 m / 980 ft. the product will follow it to the point
where the guide wire is connected to the boundary wire.
4.4.2.3 To measure the distance from the charging
station
The product follows the guide wire to measure the
distance to the charging station.
1. Put the product in the charging station.
2. Select
Test: Area 1 setup
or
Test: Area 2 setup
to
measure the distance.
3. Push the STOP button to show the distance in the
app.
4.4.3 Corridor width
The boundary wire corridor is the area adjacent to
the boundary wire. The product uses the corridors to
find the charging station. The corridor width is adjusted
automatically. If it is necessary to adjust the corridor
width manually for the product to operate satisfactorily,
you can set the corridor width between 1-9.
4.4.4 Reversing distance
The reversing distance makes the product move in
reverse for a set distance, before the product starts to
cut the lawn.
4.4.5 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 32 cm / 13 in. You can select a distance of
25-50 cm / 10-20 in.
22 - Settings 2071 - 001 - 29.03.2023
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Automower 450X NERA - 2023 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Automower 450X NERA - 2023 in the language / languages: English as an attachment in your email.

The manual is 4.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Automower 450X NERA - 2023

Husqvarna Automower 450X NERA - 2023 Quick start guide - German - 8 pages

Husqvarna Automower 450X NERA - 2023 User Manual - German - 52 pages

Husqvarna Automower 450X NERA - 2023 Quick start guide - Dutch - 8 pages

Husqvarna Automower 450X NERA - 2023 User Manual - Dutch - 52 pages

Husqvarna Automower 450X NERA - 2023 Quick start guide - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info